Introduction: Many detrimental effects on employees’ health and wellbeing might result from inadequate illumination in the workplace. Headaches and trouble focusing can result from eye strain brought on by inadequate illumination. The purpose of this study was to simulate and optimize workplace illumination in the ceramic industry. Materials and methods: A common Luxmeter ST-1300 was used to measure the illumination in seven workplaces at a height of 100 cm above the floor. DIALux evo version 7.1 software was used to simulate the illumination of workplaces. To optimize the illumination conditions, a numerical experiment design consisting of 16 scenarios was used for each of the workplaces. Four factors were considered for each scenario: luminaire height, number of luminaires, luminous flux, and light loss factor. The Design-Expert program version 13.0.5.0 was applied for developing the scenarios. Finally, by developing quadratic models for each workplace, the optimization process was implemented. Results: Every workplace had illumination levels that were measured to be between 250 and 300 lux. Instead of using compact fluorescent luminaires, LED technology was recommended to maximize the illumination conditions for the workers. Following optimization, 376 lux of illumination were visible at each workstation in every workspace. For the majority of the workspaces, the simulated illumination was expected to have a desirability degree greater than 0.9. The uniformity and illumination of the workplace were significantly impacted by the two factors of luminaire height and luminaire count. Conclusion: The primary outcomes of this optimization were the environmental, political, and socioeconomic ones, including reduced consumption power, high light flux, and environmental compatibility. Nonetheless, the optimization technique applied in this work can be applied to the design of similar situations, such as residential infrastructure.

This article examines migration as a complex social phenomenon using innovative pedagogical tools such as Story Maps and virtual ethnography. the study focuses on how these tools enhance the learning process by integrating Paulo Freire’s critical pedagogy. Original empirical data was collected from student feedback and reflective exercises, demonstrating enhanced critical thinking and engagement. The study also highlights the challenges posed by technological access inequalities, emphasizing the need for equitable solutions.

The current paper aims at spatial presentation in Cinque Terre. The purpose is to reconstruct digital products (maps, statistics, diagrams, and 3D models) and the spatial analysis of the five villages. The goals are the presentation of the geomorphology, geography, population, density, and area. Also, the Strength-Weakness-Opportunities-Threats (SWOT) analysis creates the disadvantages and advantages of the five villages in the region. The methodology is based on the software (G.I.S. Pro, QGIS, Zephyr 3D, Microsoft Excel, Generic Mapping Tool) and the bibliography study. For instance, the construction 3D terrain model shows the buildings, roads, green areas, and land cover of the five villages. The digital products help better “read” the region and emphasize the measurements and location of the region’s elements. The final results contain a message about new technologies and spatial planning. The new technologies have given spatial solutions in the last few years. The innovative, understanding, and attractive cartographical digital products present the geomorphology of the traditional villages in Cinque Terre.

This article refers to Hallstatt in Austria and Ioannina in Greece. The goals analyze the two locations that have similarities in geometric shape, digital elevation model (DEM), and geomorphology. Firstly, Hallsatt’s advances were more technical than aesthetic. There is a general tendency towards extravagance and baroque and Greco-Oriental influences. Secondly, Ioannina is a mountainous city located around Lake Pamvotis. The geometry develops parallel to the lake. The city experiences many cultures. The ancient city had an urban planning that characterized the Ottoman Empire. In the old part, there is the castle, old stone streets, wooden houses, and the house of the Greek Muslim Ali Pasha. The author obtains numerous aerial photographs using Google Earth software. The photographs were received dynamically for all the perimeters of the regions. In short, the cartographer has between 15 and 20 photographs. The next step is to align the photographs in Zephyr photogrammetry software. Configuring resolutions, distance, camera locations, contrast, and brightness is essential. The final products are the 3D texture, 3D model, and orthophotos from Hallstatt and Ioannina. Digital products are suitable for measuring areas, circumferences, and heights. Furthermore, digital products represent a digital archiving practice: conservation and visualization are crucial factors today as they share, represent, promote, and document urban planning, historical memory, and the natural environment.

Map is the basic language of geography and an indispensable tool for spatial analysis. But for a long time, maps have been regarded as an objective and neutral scientific achievement. Inspired by critical geography, critical cartography/GIS came into being with the goal of clarifying the discourse embedded in cartographic practice. Power relationship challenges the untested assumption in map representation that is taken for granted. After more than 40 years of debate and running in, this research field has initially shown an outline, and critical cartography/GIS has roughly formed two research directions: the deconstruction path mainly starts from the identity of cartography subject and the process of map knowledge production, and analyzes the inseparable relationship between cartography and national governance and its internal power mechanism respectively; the construction path mainly relies on cooperative mapping and anti-mapping to realize the reproduction of map data. Domestic critical cartography/GIS research has just started, and it is necessary to continue to absorb the achievements of critical geography and carry out research in different historical periods. The deconstruction research of different types of maps also needs to strengthen the in-depth bridging between the construction path and the deconstruction path, and to be more open to the public. Impartial map application research, and actively apply the research results to social practice.