This study comprehensively evaluates the system performance by considering the thermodynamic and exergy analysis of hydrogen production by the water electrolysis method. Energy inputs, hydrogen and oxygen production capacities, exergy balance, and losses of the electrolyzer system were examined in detail. In the study, most of the energy losses are due to heat losses and electrochemical conversion processes. It has also been observed that increased electrical input increases the production of hydrogen and oxygen, but after a certain point, the rate of efficiency increase slows down. According to the exergy analysis, it was determined that the largest energy input of the system was electricity, hydrogen stood out as the main product, and oxygen and exergy losses were important factors affecting the system performance. The results, in line with other studies in the literature, show that the integration of advanced materials, low-resistance electrodes, heat recovery systems, and renewable energy is critical to increasing the efficiency of electrolyzer systems and minimizing energy losses. The modeling results reveal that machine learning programs have significant potential to achieve high accuracy in electrolysis performance estimation and process view. This study aims to contribute to the production of growth generation technologies and will shed light on global and technological regional decision-making for sustainable energy policies as it expands.

Electrical energy is known as an essential part of our day-to-day lives. Renewable energy resources can be regenerated through the natural method within a reasonably short time and can be used to bridge the gap in extended power outages. Achieving more renewable energy (RE) than the low levels typically found in today’s energy supply network will entail continuous additional integration efforts into the future. This study examined the impacts of integrating renewable energy on the power quality of transmission networks. This work considered majorly two prominent renewable technologies (solar photovoltaic and wind energy). To examine the effects, IEEE 9-bus (a transmission network) was used. The transmission network and renewable sources (solar photovoltaic and wind energy technologies) were modelled with MATLAB/SIMULINK^®. The Newton-Raphson iteration method of solution was employed for the solution of the load flow owing to its fast convergence and simplicity. The effects of its integration on the quality of the power supply, especially the voltage profile and harmonic content, were determined. It was discovered that the optimal location, where the voltage profile is improved and harmonic distortion is minimal, was at Bus 8 for the wind energy and then Bus 5 for the solar photovoltaic source.