Introduction: the presence of anti-CCP is an important prognostic tool for rheumatoid arthritis (RA), but its relationship with the activity of the disease and functional capacity is still being investigated. Objectives: to study the relationship between anti-CCP and the indices of disease activity, functional capacity and structural damage, by means of conventional radiography (CR) and magnetic resonance imaging (MRI), in stabilized RA. Methods: cross-sectional study of RA patients with one to 10 years of disease. The participants were subjected to clinical evaluation with anti-CCP screening. Disease activity was assessed by means of the Clinical Disease Activity Index (CDAI) and functional capacity by means of the Health Assessment Questionnaire (HAQ). CR was analyzed by the Sharp van der Heijde index (SmvH) and MRI by the Rheumatoid Arthritis Magnetic Resonance Image Scoring System (RAMRIS). Results: 56 patients were evaluated, with median (IIq) of 55 (47.5–60.0) years, 50 (89.3%) were female among whom 37 (66.1%) were positive for anti-CCP. The median (IIq) of CDAI, HAQ, SmvH and RAMRIS were 14.75 (5.42–24.97), 1.06 (0.28–1.75), 2 (0–8) and 15 (7–35), respectively. There was no association between anti-CCP and CDAI, HAQ, SmvH and RAMRIS. Conclusion: our results did not establish the association of anti-CCP with the severity of the disease. So far, we cannot corroborate the anti-CCP as a prognostic tool in RA established.

Nowadays, our life needs more and more electricity, and our lives cannot be without electricity, which requires our power to develop more quickly. Power plants are undoubtedly the place where electricity is produced. And now most of the power plant or chemical energy can be converted into heat, and then through the heat to do power production. The boiler is the main part of the power plant. Boiler unit consists of boiler body equipment and auxiliary equipment. The main body of the boiler consists of 'pot' (soft drinks system) and 'furnace' (combustion system). Baotou thermal power plant is mainly burning gas. The gas and air are at a certain rate into the furnace burning. This can greatly reduce the pollution of the environment, but also the full use of fuel. The soda system is mainly carried out in the drum. The heat generated by the combustion system heats the water in the drum, producing steam and then pushing the steam turbine into mechanical energy and finally into electrical energy. This has a high demand for water level, water composition, and the temperature of the steam produced in the drum. The water level should have upper and lower bounds, keeping it within a certain range. Water level is too high, will affect the steam drum soda separation effect, so that the steam drum exports of saturated steam with water increased, causing damage to the turbine, will cause serious explosion. And the water level is too low, it will affect the natural circulation of the normal, serious will make the individual water pipe to form a free water, resulting in flow stagnation, resulting in local metal wall overheating and burst pipe. Water in the heating at the same time will form a lot of scale, if not the chemical treatment of water will be in the formation of scale in the drum, cleaning more difficult, so the damage to the drum. The pressure of the drum is also an important control variable, and pressure control is highly correlated with liquid level control. It is necessary to ensure the integrity of the equipment, but also to ensure safety, followed by ensuring that the process of normal operation of the drum water. This time, the design is mainly for the unit steam temperature control system design. Steam temperature is one of the important indicators of boiler operation quality. It is too high and too low will significantly affect the power plant safety and economy. If the temperature of the steam is low, it will cause the power plant to increase the heat consumption and increase the axial thrust of the turbine to cause the thrust bearing to overload, but also cause the steam turbine to increase the final steam humidity, thus reducing the efficiency of the turbine, aggravating the erosion of the blade. On the contrary, the steam temperature is too high will make the super-heater wall metal strength decreased, and even burn the high temperature of the super-heater, the steam pipe and steam turbine high-pressure part will be damaged, seriously affecting safety. The boiler temperature control system mainly includes the adjustment of the superheated steam and the reheat steam temperature. The superheated steam temperature is the highest temperature in the boiler soda system. The stability of the steam temperature is very important for the safe and economical operation of the unit. Therefore, in the boiler operation, must ensure that the steam temperature in the vicinity of the specified value, and the temperature of the super-heater tube wall does not exceed the allowable working temperature.

In this paper, all the forests, woodlands and trees in the administrative area of Zhaoling Township in Chuzhou City of Huai'an City were collected and analyzed. The total area of the administrative area is 4852 hectares, the forest coverage rate is 22.07%, and the forest greening rate is 26.13%. This index has exceeded 20% of the forest coverage rate of the well - off society. Tree species is particularly serious. In the forest system (pure forest), the area of pure forest of poplar is accounted for 99.9% of the whole forest area. In the four tree systems, the number of poplar trees accounted for 80% of the total number of trees in the whole tree, and the total amount of poplar trees accounted for 98%. The poplar pure forest age group structure disorders, the unit area is low. The ratio of total area of poplar pure forest in Zhongling and young forests was 92.9%, and the ratio of total area of poplar pure forest and mature forest was 7.1%. The ratio of mature forest and the ratio of mature forest was 0.7%, and the proportion of each group was obviously abnormal.

In the current era, electromagnetic radiation is everywhere. Every day electromagnetic radiation and static electricity caused by a variety of hazards. So, anti-electromagnetic radiation and anti-static awareness gradually enjoys popular support, more attention are gained by people on the anti-electromagnetic radiation and anti-static. This caused radiation protection and anti-static clothing industry’s rise by the day. Radiation protection and anti-static clothing will enter various households to provide a certain amount of protection to the people's health. We discuss two parts in this paper, specifically from the effects of the electromagnetic radiation and electrostatic effects which started on radiation clothing and anti-static clothing. The main contents of this paper are as follows: The first part of the definition of electromagnetic radiation and its brief introduction, while explaining the types of electromagnetic radiation and electromagnetic radiation sources in daily lives, followed by the emphasis of serious harms on electromagnetic radiation on human health It is precisely because of electromagnetic radiation on people's lives have serious threat, that makes the development of radiation protection. This follows the basic introduction of the radiation suit and the development of radiation protection clothings. The development of radiation protection suits is an established industry. Materials made of radiation protection are constantly changing, but their basic working principle has not changed. Followed by the introduction of the basic principles of radiation protection clothings, we theoretically present specific analysis and demonstration. However, the theoretical analysis and practice is often consists a certain gap, so we highlight a few actual situations on the impact of radiation protection clothings. Finally, we present a simple discussion on wide range of applications of radiation protection clothings. The thought process of second part is similar as the first part, respectively, we introduce the health hazards and the impact on people's lives of electrostatic effect and static electricity . Followed by that it is the basic principles, relevant analysis and discussion of anti-static clothing Finally, we provide the detailed explanation of the application of anti-static clothing.

The size effect on the free vibration and bending of a curved FG micro/nanobeam is studied in this paper. Using the Hamilton principle the differential equations and boundary conditions is derived for a nonlocal Euler-Bernoulli curved micro/nanobeam.  The material properties vary through radius direction. Using the Navier approach an analytical solution for simply supported boundary conditions is obtained where the power index law of FGM, the curved micro/nanobeam opening angle, the effect of aspect ratio and nonlocal parameter on natural frequencies and the radial and tangential displacements were analyzed. It is concluded that increasing the curved micro/nanobeam opening angle results in decreasing and increasing the frequencies and displacements, respectively. To validate the natural frequencies of curved nanobeam, when the radius of it approaches to infinity, is compared with a straight FG nanobeam and showed a good agreement.

The paper examines the motivations, financing, expansion and challenges of the Belt and Road Initiative (BRI). The BRI was initially designed to address China’s overcapacity and promote economic growth in both China and in countries along the “Belt” and “Road” through infrastructure investment and industrial capacity cooperation. It took into account China’s strategic transition in its opening-up policy and foreign policy to pay more attention to the neighboring countries in Southeast Asia and Central and West Asia when facing greater strategic pressure from the United States in East Asia and the Pacific region. More themes have been added to the initiative’s original framework since its inception in 2013, including the vision of the BRI as China’s major solution to improve international economic cooperation and practice to build a “community of shared future for mankind”, and the idea of the Green Silk Road and the Digital Silk Road. Chinese state-owned enterprises and policy and commercial banks have dominated investment and financing for BRI projects, which explains the root of the problems and risks facing the initiative, such as unsustainable debt, non-transparency, corruption and low economic efficiency. Measures taken by China to tackle these problems, for example, mitigating the debt distress and improving debt sustainability, are unlikely to make a big difference anytime soon due to the tenacity of China’s long-held state-driven investment model.