Asian Infrastructure Investment Bank’s president Mr. Jin Liqun shares with JIPD Editor-in-Chief, Dr. Gu Qingyang, his passion for infrastructure finance, as he reflects upon his goal of steering an environmentally friend and corruption-free AIIB toward building social-impacting infrastructure across Asia.
From governmental departments to international financial institutes, Mr. Jin Liqun has undertaken almost every essential role in finance. With his vast experience across the private and public sectors, particularly in multilateral development banks, Mr. Jin Liqun currently serves as Asian Infrastructure Investment Bank (AIIB)’s first President since its founding in 2016, following a stint as Secretary-General of the Multilateral Interim Secretariat created to establish the bank. Beginning from his two decades of governmental experience at the Chinese Ministry of Finance, rising from the rank of Deputy Director General to Vice Minister, Mr. Jin was then called to serve as Vice President, and then Ranking Vice President, of the Asian Development Bank, and later as Alternate Executive Director for China at the World Bank and at the Global Environment Facility. Mr. Jin had also served as Chairman of China International Capital Corporation Ltd., China’s first joint-venture investment bank, in addition to serving as Chairman of the Supervisory Board of the sovereign wealth fund China Investment Corporation and as Chairman of the International Forum of Sovereign Wealth Funds.

Electricity generation around the world is mainly produced by using non-renewable energy sources especially in the commercial buildings. However, Rooftop solar Photovoltaic (PV) system produced a significant impact on environmental and economical benefits in comparison to the conventional energy sources, thus contributing to sustainable development. Such PV’s system encourages the production of electricity without greenhouse gas emissions that leads to a clean alternative to fossil fuels and economic prosperity even in less developed areas. However, efficiency of rooftop solar PV systems depends on many factors, the dominant being geographical (latitude, longitude, and solar intensity), environmental (temperature, wind, humidity, pollution, dust, rain, etc.) and the type of PV (from raw material extraction and procurement, to manufacturing, disposal, and/or recycling) used. During the feasibility analysis of the environment, geographical conditions are keep in well consideration, but the pollution level of the city is always overlooked, which significantly influences the performance of the PV installations.     

Therefore, this research work focused on the performance of rooftop solar PV installed in one of the most polluted city in India. Here, the loss in power generation of rooftop solar PV has been studied for the effect of deposited dust particles, wind velocity before and after the cleaning of the panels. The actual data has been utilized for the calculation of the energy efficiency and power output of the PV systems. According to the results, it has been concluded that dust deposition, wind speed and pollution level in city significantly reduces the efficiency of solar photovoltaic panel. Hence, an overview of social and environmental impacts of PV technologies is presented in this paper along with potential benefits and pitfalls.

ZrO₂ thin film samples were produced by the sol-gel dip coating method. Four different absorbed dose levels (such as ~ 0.4, 0.7, 1.2 and 2.7 Gray-Gy) were applied to ZrO₂ thin films. Hence, the absorbed dose of ZrO₂ thin film was examined as physical dose quantity representing the mean energy imparted to the thin film per unit mass by gamma radiation. Modification of the grain size was performed sensitively by the application of the absorbed dose to the ZrO₂ thin film. Therefore the grain size reached from ~50 nm to 87 nm at the irradiated ZrO₂ thin film. The relationship of the grain size, the contact angle, and the refractive index of the irradiated ZrO₂ thin film was investigated as being an important technical concern. The irradiation process was performed in a hot cell by using a certified solid gamma ray source with 0.018021 Ci as an alternative technique to minimize the utilization of extra toxicological chemical solution. Antireflection and hydrophilic properties of the irradiated ZrO₂ thin film were slightly improved by the modification of the grain size. The details on the optical and structural properties of the ZrO₂ thin film were examined to obtain the optimum high refractive index, self-cleaning and anti-reflective properties.

The ways of developing functional textiles based on nanomaterials were introduced, and the latest research achievements of nanomaterials in such aspects as flame retardancy, antibacterial, super-hydrophobic, self-cleaning, UV resistance, and anti-static textiles were reviewed. The main technical obstacles to the large-scale application of nanomaterials in functional textiles were pointed out, the possible solutions were discussed, and the development of functional textiles by nanomaterials has been prospected.

Cucumber (Cucumis sativus L.) is a tropical vegetable and a source of vitamins such as K, C, and B. It is commonly grown and sold for daily consumption, but picking the right fruit size is more profitable. Therefore, a method for estimating the fruit weight is highly recommended. This paper aimed to determine the dimensions of cucumber fruit based on its usual harvesting size and to establish a model to show the relationship between fruit weight, fruit length, and fruit diameter. Cucumber was planted in the experimental field belonging to the Faculty of Agricultural Biosystems Engineering, Royal University of Agriculture, Phnom Penh, Cambodia, from January to June 2022. In the study, 48 market-size fruits were randomly selected from the plots to measure their weight, length, and diameter. The result shows that fruit length and fruit diameter had a positive relationship (P < 0.001; R = 0.70). Fruit weight was 3.38 fruit length × fruit diameter (P <0.001; R = 0.95). Nevertheless, L/D ratio negatively affected fruit weight, when it exceeded 3:1. Fruit weight was greater than 100 g when fruit diameter was over 4 cm and fruit length was over 10 cm. Therefore, when picking cucumber fruits, one must consider fruit length and diameter to be profitable. Further studies will focus on measuring cucumber fruit already available on the market to understand more about actual consumer preferences.