Objective: to determine the diagnostic performance of magnetic resonance hysterosalpingography (HSG-MRI), using laparoscopy as the reference method. Materials and methods: 22 patients were included. All underwent HSG-MRI with a 1.5 Tesla resonator and then laparoscopy with chromotubation. Two radiologists examined the MRIs, determining tubal patency by consensus. Descriptive and diagnostic performance analyses were performed. Results: HSG-MRI had a success rate of 91%. Study duration was 49 ± 15 minutes, volume injected 26 ± 16 cm3 and pain scale 30 ± 19 out of 100. Sensitivity and specificity of HSG-MRI were 100% for global and left Cotte test, and 25% and 93.3% for right Cotte test, respectively. There were 2 minor complications and no major complications. Discussion: our initial results demonstrated high sensitivity and specificity. Although other studies analyzed the ability of HSG-MRI to assess tubal patency with good results, the use of a flawed reference standard left room for reasonable doubt, preventing a recommendation based on solid evidence. However, when comparing our results with those published, we observed a high degree of concordance insofar as the positive effusion is correctly diagnosed with a specificity of 100% or with a percentage close to this figure.
Lithospermum extract from Lithospermum is a kind of naphthoquinone, which has good anti-ultraviolet and anti-bacterial function. In this paper, the effects of different treatment temperature, time and ratio of liquid to liquid on the UV resistance of Lithospermum erythrorhizon extract were studied. The optimum extraction conditions were as follows: extraction temperature 60 ℃, extraction time 2 h, ratio of liquid to liquid of Lithospermum and ethanol 1:11. In this paper, the anti-UV finishing of cotton fabric was carried out, and the anti-ultraviolet and whiteness of the fabric were taken as the main indexes. The optimum process of the anti-UV finishing was as follows: the impregnation temperature was 70 ℃, the immersion time was 2h, 1:40. Compared with the uncoated cotton fabric, the fabric UPF value of the fabric was improved from 12.31 to 83.25, and the anti-ultraviolet performance was excellent, and it had certain bacteriostatic effect on Bacillus subtilis and Escherichia coli.
Fe3+-doped nano-TiO2 powders were prepared by sol-gel method. The photocatalytic activity of Fe3+-doped TiO2 nanoparticles was studied by using UV lamp as light source and methylene blue as degradation target. The photocatalytic activity of Fe3+-doped TiO2 was studied by degradation of 4L methylene blue solution with initial concentration of 10mg · L - 1. The results show that the photocatalytic activity of TiO2 can be improved by the addition of Fe3+. When the molar ratio of Fe3+ is 0.5-1%, the calcination temperature is 500 ℃. The photocatalytic degradation of methylene blue is the best.
The development status of flat panel solar water heater and the composition of water heater are described. The solar radiation in three typical weather conditions of sunny, cloudy and rainy days is studied. The hot water temperature, heat and heat collector efficiency are studied. The results show that the influence of the weather on the solar irradiance is large, and the irradiance has a great influence on the water temperature.
This study examines conditions that impact PPP delivery success or failure in the roadways sector in India using Qualitative Comparative Analysis. QCA is well-suited for problems where multiple factors combine to create pathways leading to an outcome. Past investigations have compared PPP and non-PPP project delivery performance, but this study examines performance within PPPs by uncovering a set of conditions that combine to influence the success or failure road PPP project delivery in India. Based on data from 21 cases, pathways explaining project delivery success or failure were identified. Specifically, PPPs with high concessionaire equity investment and low regional industrial activity led to project delivery success. Projects with lower concessionaire equity investment and low reliance on toll revenue and with either: (a) high project technical complexity or (b) high regional industrial activity, led to project delivery failure. The pathways identified did not have coverage values that they were extremely strong. Coverage strength was hindered by lack of access to information on additional conditions that could be configurationally important. Further, certain characteristics of the Indian market limit generalization. Identification of combinations of conditions leading to PPP project delivery success or failure improves knowledge of the impacts of structure and characteristics of these complex arrangements. This study is one of the first to use fuzzy QCA to understand project delivery success/failure in road PPP projects. Moreover, this study takes into account factors specific to a sector and delivery mode to explain project delivery performance.
Over the past decade, Ontario has seen a renewal in efforts to stimulate economic growth by investing in infrastructures. In this paper, we analyze the impact of public infrastructure investment on economic performance in this province. We use a multivariate dynamic time series methodological approach, based on the use of vector autoregressive models to estimate the elasticities and marginal products of six different types of public infrastructure assets on private investment, employment and output. We find that all types of public investment crowd in private investment while investment in highways, roads, and bridges crowds out employment. We also find that all types of public investment, with the exception of highways, roads and bridges, have a positive effect on output. The relatively large range of results estimated for the impact of each of the different public infrastructure types suggests that a targeted approach to the design of infrastructure investment policy is required. Infrastructure investment in transit systems and health facilities display the highest returns for output and the largest effects on employment and labor productivity. In terms of the nature of the empirical results presented here it would be important to highlight the fact that investments in health infrastructures as well as investments in education infrastructures are of great relevance. This is a pattern consistent with the mounting international evidence on the importance of human capital for long term economic performance.
Copyright © by EnPress Publisher. All rights reserved.