The objective of the present study is to observe the surface morphology, structure and elemental composition of the ash particles produced from some thermal power stations of India using scanning electron microscopy (SEM) and energy dispersive X-ray analysis (EDXA). This information is useful to better understand the ash particles before deciding its utility in varied areas.

In this investigation the effect of collection seasons of explants (winter, spring and summer), type of explants (leaf disc and intermodal segments) and length of explants (0.5, 1.0 and 1.5 cm) for callusing in low-chill peach were standardized. The maximum callus induction (97.78%) in the low-chill peach was obtained from the intermodal segments of 0.5 cm in length used as an explant collected during spring season. The structural changes on the surface of the callus (5–7 weeks old yellowish green compact callus) during the progress of somatic embryogenesis of low-chill peach from the both intermodal segment as well as leaf disc derived callus were also examined with the use of scanning electron microscope (SEM). The SEM studies indicated that callus derived from internodal segment explant had the highest frequency of somatic embryos than callus from leaf discs. The SEM investigation, also demonstrated the sequential events/steps leading to low-chill peach somatic embryogenesis which was originating from somatic embryo mother cells through one unicellular pathway. Two types of calli were morphologically distinguished in both leaf disc and intermodal segment generated callus and these were the compact, well organized yellowish green embryogenic callus, containing large number of small, rich cytoplasmic, starch containing meristematic cells and soft and unorganized non-embryogenic callus containing sparsely cytoplasmic, vacuolated, and large cells devoid of metabolic reserves. The present SEM studies clearly demonstrated that somatic cells from peach explants generated callus could develop into fully differentiated somatic embryos through the characteristic embryological patterns of differentiation.

Industrial plastics have seen considerable progress recently, particularly in manufacturing non-lethal projectile holders for shock absorption. In this work, a variety of percentages of alumina (Al₂O₃) and carbon black (CB) were incorporated into high-density polyethylene (HDPE) to investigate the additive material effect on the consistency of HDPE projectile holders. The final product with the desired properties was controlled via physical, thermal, and mechanical analysis. Our research focuses on nanocomposites with a semicrystalline HDPE matrix strengthened among various nanocomposites. In the presence of compatibility, mixtures of variable compositions from 0 to 3% by weight were prepared. The reinforcement used was verified by X-ray diffraction (XRD) characterization, and thermogravimetric analysis (TGA) and differential scanning calorimetry (DSC) were used for thermal property investigation. Alumina particles increased the composites’ thermal system and glass transition temperature. Mechanical experiments indicate that incorporating alumina into the matrix diminishes impact resistance while augmenting static rupture stress. Scanning electron microscopy (SEM) revealed a consistent load distribution. Ultimately, we will conduct a statistical analysis to compare the experimental outcomes and translate them into mathematical answers that elucidate the impact of filler materials on the HDPE matrix.