The structure, thermodynamic stability, ionization potential (IP) and electron affinity (EA) energy level difference (E_g) and tension of lowest unoccupied orbit (LUMO) and highest occupied orbit (HOMO) of armchair single wall carbon nanotubes (C-NTs), BN hybrid carbon nanotubes (BC₂N-NTs) and all BN nanotubes (BN-NTs) were systematically studied with AM1 method in this paper. Calculation results show that when n value is constant, (n, n) C-NTs (n = 3,4,5,6) has the largest diameter and BN-NTs has the smallest diameter; (n, n) the values of E_g (HOMO-LUMO) and n of C-NTs and BC₂N-NTs are related; POAV analysis shows that different hybrid atoms have different contributions to the hybrid mode of nanotube atoms and the tension of nanotubes.

Phytomediation is an environmentally friendly green rehabilitation technology that is often incorporated with an application to improve calcium peroxide and phytohormones required for the growth of agricultural plants with the expectation to improve the effectiveness of plant rehabilitation. This study mainly consists of two parts: (1) water culture experiment and (2) pot culture experiment. In the water culture experiment, we attempt to understand the influence of the addition of calcium peroxide, phytohormones (IAA and GA₃) and a chelating agent on the growth of sunflower plants. However, in the pot culture experiment, when hormones and the chelating agent EDTA are introduced to different plant groups at the same time, if the nutrition in the water required by plants is not available, the addition of the hormone cannot negate the toxicity caused by EDTA. In terms of calcium peroxide, due to quick release of oxygen in water, this study fails to apply calcium peroxide to the water culture experiment.

When the pot culture experiment is used to examine the influence of hormones at different concentration levels on the growth of sunflowers, GA₃ 10^-8 M is reported to have the optimal effectiveness, followed by IAA 10^-8 M; IAA 10^-12 M has the lowest effectiveness. According to an accumulation analysis of heavy metals at different levels, GA₃ concentrates in leaves to transport nutrition in soil to leaves. This results in an excellent TF value of 2.329G of GA₃ than 1.845 of the control group indicating that the addition of the hormone and chelating agent to GA₃ increases the TF value and the chelating agent is beneficial to the sunflower plant. If we examine phytoattenuation ability, the one-month experiment was divided into three stages for ten days each. The concentration level of heavy metals in the soil at each stage dropped continuously while that of the control group decreased from 31.63 mg/kg to 23.96 mg/kg, GA₃ from 32.09 mg/kg to 23.04 mg/kg and EDTA from 30.65 mg/kg to 25.93 mg/kg indicating the quickest growth period of the sunflowers from the formation of the bud to blossom. During the stage, the quick upward transportation of nutrition results in quick accumulation of heavy metals; the accumulated speed of heavy metals is found higher than that of directly planted plants. This study shows an improvement in the effectiveness of the addition of hormones on plant extraction and when rehabilitation is incorporated with sunflowers with the beginning bud formation, better treatment effectiveness can be reached.

The need for global energy conservation has become more urgent because of the negative effects of excessive energy use, such as higher fuel consumption, greater environmental pollution, and depletion of the ozone layer. There has been a significant increase in the demand for central and high-capacity household air conditioning systems in Muscat in recent years. The need for this is influenced by factors such as arid climate, increasing temperatures, air pollution, and population increase. As a result, there has been a significant increase in electricity use, putting a strain on power resources. To tackle this difficulty, the incorporation of solar collectors as supplementary thermal compressors in air conditioning systems offers a chance to utilise renewable energy sources. The objective of this hybrid technique is to enhance the effectiveness of cooling systems, hence minimising the need for electricity and lowering the release of environmental pollutants.

The interest in smart grids and new technologies is growing around the world. Countries are investing in the development of new technologies that will help achieve environmental goals, energy supply efficiency, improve energy efficiency and increase consumer involvement in the energy generation. One of such technology is a blockchain. It is believed that the blockchain, combined with a smart grid, provides an opportunity to integrate the activities of all stakeholders, including: generators, distributors and consumers of electricity. The aim of the article is to identify the key research areas discussed by the researchers of both the smart grid and the blockchain issues. An analysis of the Scopus database from 2015 to 2023 was conducted. Using a created bibliometric query, a systematic literature review was conducted. 476 scientific publications relating to the issues addressed were identified. Using the VOSviewer software, a bibliometric analysis was performed using the author’s keywords. The bibliometric maps obtained allowed for the identification of key research areas. The article also presents potential future directions of scientific considerations, which should be focused on the issue of green smart grid and green blockchain. The results presented in the article can inspire researchers looking for research gaps or describing the current state of knowledge in the field of the smart grid and the blockchain issues.

The obtaining of new data on the transformation of parent materials into soil and on soil as a set of essential properties is provided on the basis of previously conducted fundamental studies of soils formed on loess-like loams in Belarus (15,000 numerical indicators). The study objects are autochthonous soils of uniform granulometric texture. The basic properties without which soils cannot exist are comprehensively considered. Interpolation of factual materials is given, highlighting the essential properties of soils. Soil formation is analyzed as a natural phenomenon depending on the life activity of biota and the water regime. Models for differentiation of the chemical profile and bioenergy potential of soils are presented. The results of the represented study interpret the available materials taking into account publications on the biology and water regime of soils over the past 50 years into three issues: the difference between soil and soil-like bodies; the soil formation as a natural phenomenon of the mobilization of soil biota from the energy of the sun, the atmosphere, and the destruction of minerals in the parent materials; and the essence of soil as a solid phase and as an ecosystem. The novelty of the article study is determined by the consideration of the priority of microorganisms and water regime in soil formation, chemical-analytical identification of types of water regime, and determination of the water regime as a marker of soil genesis.

This paper is devoted to the determination of the dispersive component of the surface energy of two boron materials such as h-BN and BPO₄ surfaces by using the inverse gas chromatography (IGC) at infinite dilution. The specific interactions and Lewis’s acid-base parameters of these materials were calculated on the light of the new thermal model concerning the dependency of the surface area of organic molecules on the temperature, and by using also the classical methods of the inverse gas chromatography as well as the different molecular models such as Van der Waals, Redlich-Kwong, Kiselev, geometric, Gray, spherical, cylindrical and Hamieh models. It was proved that h-BN surface exhibits higher dispersive surface energy than BPO₄ material.

The specific properties of interaction of the two boron materials were determined. The results obtained by using the new thermal model taking into account the effect of the temperature on the surface area of molecules, proved that the classical IGC methods, gave inaccurate values of the specific parameters and Lewis’s acid base constants of the solid surfaces. The use of the thermal model allowed to conclude that h-BN surface has a Lewis basicity twice stronger than its acidity, whereas, BPO₄ surface presents an amphoteric character.