Ancient Minipe Anicut, Sri Lanka is world-famous for its engineering excellence. Due to its importance, conserving the ancient anicut, another anicut was constructed downstream in the 20th century. Nevertheless, the water diverted from the ancient anicut to the Minipe Left Bank (LB) Canal was kept as it was due to inherited agricultural importance. This research focuses on studying the contributions made by the adjacent catchment along the Minipe LB Canal. There are several level crossings along the Minipe Left Bank Canal from which the runoff of the local catchment flow into the Minipe LB Canal. Hydrologic Modeling System (HEC-HMS) is used to obtain the yield from each catchment into the Canal, which was compared with the annual diversions from Minipe anicut. The total yield from each stream has been compared with the annual diversion of the Minipe LB Canal from 2014 to 2020. The results obtained from this study reveal that there is sufficient water available for water augmentation in the basin, with an estimated annual average cumulative yield from the catchment of 453.6 MCM. This cumulative yield is 1.7 times the annual average diversion from the Mahaweli River, which is 271.9 MCM. With the findings, it is concluded that there is a potential to augment water from the catchment to address pertaining water shortages conveyance in the command area.

Hydroponics is a modern agricultural system that enables year-round plant growth. Biochar, derived from apple tree waste, and humic acid were investigated as a replacement for the Hoagland nutrient solution to grow strawberries in a greenhouse with three replications. Growth parameters, such as leaf area, the average number of fruits per plant, maximum fruit weight, and the weight of fresh and dry fruits, were measured. A 50% increase in fresh and dry fruit weight was observed in plants grown using biochar compared to the control. Additionally, the use of Hoagland chemical fertilizer led to a 25% increase in both fresh and dry weight. There was a 65% increase in the number of fruits per plant in the biochar-grown sample compared to the control. Moreover, biochar fertilizer caused a 100% increase in maximum fruit weight compared to the control and a 27% increase compared to the Hoagland chemical fertilizer. Biochar had a higher pH compared to the Hoagland solution, and such pH levels were conducive to strawberry plant growth. The results indicate that biochar has the potential to enhance the size and weight of fruits. The findings of the study demonstrate that biochar, when combined with humic acid, is a successful organic hydroponic fertilizer that improves the quality and quantity of strawberries. Moreover, this approach enables the more efficient utilization of garden waste.

In light of swift urbanization and the lack of precise land use maps in urban regions, comprehending land use patterns becomes vital for efficient planning and promoting sustainable development. The objective of this study is to assess the land use pattern in order to catalyze sustainable township development in the study area. The procedure adopted involved acquiring the cadastral layout plan of the study area, scanning, and digitizing it. Additionally, satellite imagery of the area was obtained, and both the cadastral plan and satellite imagery were geo-referenced and digitized using ArcGIS 9.2 software. These processes resulted in reasonable accuracy, with a root mean square (RMS) error of 0.002 inches, surpassing the standard of 0.004 inches. The digitized cadastral plan and satellite imagery were overlaid to produce a layered digital map of the area. A social survey of the area was conducted to identify the specific use of individual plots. Furthermore, a relational database system was created in ArcCatalog to facilitate data management and querying. The research findings demonstrated the approach's effectiveness in enabling queries for the use of any particular plot, making it adaptable to a wide range of inquiries. Notably, the study revealed the diverse purposes for which different plots were utilized, including residential, commercial, educational, and lodging. An essential aspect of land use mapping is identifying areas prone to risks and hazards, such as rising sea levels, flooding, drought, and fire. The research contributes to sustainable township development by pinpointing these vulnerable zones and providing valuable insights for urban planning and risk mitigation strategies. This is a valuable resource for urban planners, policymakers, and stakeholders, enabling them to make informed decisions to optimize land use and promote sustainable development in the study area.

The study focused on investigating the effects of varying levels of HA (HA₁ = 0, HA₂ = 25, HA₃ = 50, HA₄ = 75, and HA₅ = 100) on Red Dragon, Red Prince, and Red Meat varieties of red radish. This analysis aimed to unravel the relationship between different levels of HA and their impact on the growth and productivity of red radish genotypes. The findings revealed that the Red Prince genotype attained the utmost plant height of 24.00 cm, an average of 7.50 leaves per plant, a leaf area of 23.11 cm², a canopy cover of 26.76%, a leaf chlorophyll content of 54.60%, a leaf fresh weight of 41.16 g, a leaf dry weight of 8.20 g, a root length measuring 9.73 cm, a root diameter of 3.19 mm, a root fresh weight of 27.60 g, a root dry weight of 6.75 g, and a remarkable total yield of 17.93 tons per hectare. The implications of this study are poised to benefit farmers within the Dera Ismail Khan Region, specifically in the plain areas of Pakistan, by promoting the cultivation of the Red Prince variety.

Although dykes are a predominant and widely distributed phenomenon in S-Algeria, N-Mali and N-Niger, a systematic, standardized inventory of dykes covering these areas has not been published so far. Remote sensing and geo information system (GIS) tools offer an opportunity for such an inventory. This inventory is not only of interest for the mining industry as many dykes are related to mineral occurrence of economic value, but also for hydrogeologic investigations (dykes can form barriers for groundwater flow). Surface-near dykes, major fault zones, volcanic and structural features were digitized based on Landsat 8 and 9, Sentinel 2, Sentinel 1 and ALOS PALSAR data. High resolution images of World Imagery files/ESRI and Bing Maps Aerial/Microsoft were included into the evaluations. More than 14,000 dykes were digitized and analyzed. The evaluations of satellite images allow a geomorphologic differentiation of types of dykes and the description of their characteristics such as dyke swarms or ring dykes. Dykes are tracing zones of weakness like faults and zones with higher geomechanically strain. Dyke density calculations were carried out in ArcGIS to support the detection of dyke concentrations as stress indicator. Thus, when occurring concentrated, they might indicate stressed areas where further magmatic and earthquake activity might potentially happen in future.

The idea of a smart city has evolved in recent years from limiting the city’s physical growth to a comprehensive idea that includes physical, social, information, and knowledge infrastructure. As of right now, many studies indicate the potential advantages of smart cities in the fields of education, transportation, and entertainment to achieve more sustainability, efficiency, optimization, collaboration, and creativity. So, it is necessary to survey some technical knowledge and technology to establish the smart city and digitize its services. Traffic and transportation management, together with other subsystems, is one of the key components of creating a smart city. We specify this research by exploring digital twin (DT) technologies and 3D model information in the context of traffic management as well as the need to acquire them in the modern world. Despite the abundance of research in this field, the majority of them concentrate on the technical aspects of its design in diverse sectors. More details are required on the application of DTs in the creation of intelligent transportation systems. Results from the literature indicate that implementing the Internet of Things (IoT) to the scope of traffic addresses the traffic management issues in densely populated cities and somewhat affects the air pollution reduction caused by transportation systems. Leading countries are moving towards integrated systems and platforms using Building Information Modelling (BIM), IoT, and Spatial Data Infrastructure (SDI) to make cities smarter. There has been limited research on the application of digital twin technology in traffic control. One reason for this could be the complexity of the traffic system, which involves multiple variables and interactions between different components. Developing an accurate digital twin model for traffic control would require a significant amount of data collection and analysis, as well as advanced modeling techniques to account for the dynamic nature of traffic flow. We explore the requirements for the implementation of the digital twin in the traffic control industry and a proper architecture based on 6 main layers is investigated for the deployment of this system. In addition, an emphasis on the particular function of DT in simulating high traffic flow, keeping track of accidents, and choosing the optimal path for vehicles has been reviewed. Furthermore, incorporating user-generated content and volunteered geographic information (VGI), considering the idea of the human as a sensor, together with IoT can be a future direction to provide a more accurate and up-to-date representation of the physical environment, especially for traffic control, according to the literature review. The results show there are some limitations in digital twins for traffic control. The current digital twins are only a 3D representation of the real world. The difficulty of synchronizing real and virtual world information is another challenge. Eventually, in order to employ this technology as effectively as feasible in urban management, the researchers must address these drawbacks.