This study aims to determine the effects of monosodium glutamate (MSG) dosage on the yield of long beans (Vigna sinensis L.) of the Peleton variety. The use of MSG as a food ingredient has been a topic of debate, but research on its impact on plant growth is still limited, especially regarding long beans. Therefore, this research is important for providing further understanding of the influence of MSG on long beans plants. The study was conducted from July to October 2023 in Mata Air Village, Central Kupang District, Kupang Regency, East Nusa Tenggara Province. The research method used was a Randomized Complete Block Design (RCBD) with 9 treatments and 3 replications. The treatments included: No MSG, MSG at doses of 2.5 g/plant, 5 g/plant, 7.5 g/plant, 10 g/plant, 12.5 g/plant, 15 g/plant, 17.5 g/plant, and 20 g/plant. Parameters observed included flowering age (days), number of pods (pieces), pod length (cm), and pod weight (g). Based on the results and discussion, it can be concluded that MSG application had a significant effect on the number, length, and weight of pods, but had a non-significant effect on flowering age. The treatment of 15 g/plant was identified as the optimal MSG dosage for the plants, resulting in the highest number of pods (16.2), longest pod length (60.4 cm), and highest pod weight (256.4 g/plant). This research is innovative in exploring the potential use of monosodium glutamate (MSG) on long beans plants, particularly the Peleton variety. The focus on MSG application as a growth stimulant is an innovative step that has been less studied previously. The discovery of the optimal MSG dosage (15 g/plant) for achieving the best results provides valuable information for farmers to enhance productivity efficiently, sustainably, and environmentally friendly. Information about MSG’s potential as a plant stimulant can serve as a starting point for more sustainable agricultural strategies aimed at optimizing available resources.

The purpose of this study is to predict the frequency of mortality from urban traffic injuries for the most vulnerable road users before, during and after the confinement caused by COVID-19 in Santiago de Cali, Colombia. Descriptive statistical methods were applied to the frequency of traffic crash frequency to identify vulnerable road users. Spatial georeferencing was carried out to analyze the distribution of road crashes in the three moments, before, during, and after confinement, subsequently, the behavior of the most vulnerable road users at those three moments was predicted within the framework of the probabilistic random walk. The statistical results showed that the most vulnerable road user was the cyclist, followed by motorcyclist, motorcycle passenger, and pedestrian. Spatial georeferencing between the years 2019 and 2020 showed a change in the behavior of the crash density, while in 2021 a trend like the distribution of 2019 was observed. The predictions of the daily crash frequencies of these road users in the three moments were very close to the reported crash frequency. The predictions were strengthened by considering a descriptive analysis of a range of values that may indicate the possibility of underreporting in cases registered in the city’s official agency. These results provide new elements for policy makers to develop and implement preventive measures, allocate emergency resources, analyze the establishment of policies, plans and strategies aimed at the prevention and control of crashes due to traffic injuries in the face of extraordinary situations such as the COVID-19 pandemic or other similar events.

A Detailed geophysical investigation was conducted on Knossos territory of Crete Island. Main scope was the detection of underground archaeological settlements. Geophysical prospecting applied by an experienced geophysical team. According to area dimensions in relation to geological and structural conditions, the team designed specific geophysical techniques, by adopted non-catastrophic methods. Three different types of geophysical techniques performed gradually. Geophysical investigation consisted of the application of geoelectric mapping and geomagnetic prospecting. Electric mapping focusses on recording soil resistance distribution. Geomagnetic survey was performed by using two different types of magnetometers. Firstly, recorded distribution of geomagnetic intensity and secondly alteration of vertical gradient. Measured stations laid along the south-north axis with intervals equal to one meter. Both magnetometers were adjusted on a quiet magnetic station. Values were stored in files readable by geophysical interpretation software in XYZ format. Oasis Montaj was adopted for interpretation of measured physical properties distribution. Interpretation results were illustrated as color scale maps. Further processing applied on magnetic measurements. Results are confirmed by overlaying results from three different techniques. Geoelectric mapping contributed to detection of a few archaeological targets. Most of them were recorded by geomagnetic technique. Total intensity aimed to report the existence of magnetized bodies. Vertical gradient detected subsurface targets with clearly geometrical characteristics.

Introduction: It is universally accepted that the posteroanterior skull radiograph shows a lower degree of distortion than other radiographic images, so that measurements on it are considered reliable. Objective: To determine the percentage of distortion in the different facial regions of the postero-anterior skull radiograph. Methods: Thirty human skulls with their jaws were divided by three horizontal and four vertical planes into fifteen quadrants; there were ten in the skull and five in the jaw. On each of them a steel wire was placed in vertical and horizontal positions and their length (actual measurement) was measured. Each set was X-rayed in posteroanterior projection and the length of the wires was measured in the image (radiographic measurement). Results: It was not possible to measure in the lateral quadrants of the skull. The horizontal measurement in the right and left lower intermediate quadrants of the skull and in the intermediate and lateral quadrants of both sides of the mandible is not reliable; in the median quadrant of the mandible it is minimized; in the right and left upper intermediate and median quadrants of the skull and in the median of the mandible it is magnified. Vertical measurements in all quadrants are reliable; in the right and left upper intermediate and left upper and middle quadrants of the skull and in the right and left middle and lateral quadrants of the mandible it is magnified; in the lower intermediate and upper and lower middle quadrants of the skull and median of the mandible it is minimized. The least distortion for both measurements occurs in the upper median quadrant of the skull. Percentages of distortion are reported for each quadrant. Conclusions: Distortion is present in the posteroanterior skull radiograph and varies from one region of the face to another.

In order to strengthen the study of soil-landscape relationships in mountain areas, a digital soil mapping approach based on fuzzy set theory was applied. Initially, soil properties were estimated with the regression kriging (RK) method, combining soil data and auxiliary information derived from a digital elevation model (DEM) and satellite images. Subsequently, the grouping of soil properties in raster format was performed with the fuzzy c-means (FCM) algorithm, whose final product resulted in a fuzzy soil class variation model at a semi-detailed scale. The validation of the model showed an overall reliability of 88% and a Kappa index of 84%, which shows the usefulness of fuzzy clustering in the evaluation of soil-landscape relationships and in the correlation with soil taxonomic categories.

In view of the large energy consumption of the regeneration process in the chemical absorption decarburization process, on the basis of the enrichment classification flow process, the nanoscale ceramic film is used as a new heat exchanger between the enriched liquid and the regeneration gas. The porous ceramic film is capable of coupling thermal-mass transfer to effectively recover part of the water vapor and the heat carried in the regeneration gas, so as to reduce the regenerative energy consumption of the system. The effects of parameters such as regeneration temperature, flow rate, molar fraction of water vapor, and MEA enrichment temperature, flow rate, and MEA concentration of shunt on the hydrothermal recovery effect of ceramic membranes of different pore sizes and lengths were studied by using the heat recovery flux and water recovery rate as the indicators. The results show that the hydrothermal recovery performance of the ceramic membrane increases with the increase of MEA enrichment flow, but decreases significantly with the increase of the enrichment temperature. At the same time, with the increase of regenerative gas velocity and the molar fraction of water vapor in the regenerative gas, the heat recovery flux will increase. The heat recovery performance of the 10 nm ceramic membrane is better than that of the 20 nm ceramic membrane.