The objective of the present study is to observe the surface morphology, structure and elemental composition of the ash particles produced from some thermal power stations of India using scanning electron microscopy (SEM) and energy dispersive X-ray analysis (EDXA). This information is useful to better understand the ash particles before deciding its utility in varied areas.

Phytomediation is an environmentally friendly green rehabilitation technology that is often incorporated with an application to improve calcium peroxide and phytohormones required for the growth of agricultural plants with the expectation to improve the effectiveness of plant rehabilitation. This study mainly consists of two parts: (1) water culture experiment and (2) pot culture experiment. In the water culture experiment, we attempt to understand the influence of the addition of calcium peroxide, phytohormones (IAA and GA₃) and a chelating agent on the growth of sunflower plants. However, in the pot culture experiment, when hormones and the chelating agent EDTA are introduced to different plant groups at the same time, if the nutrition in the water required by plants is not available, the addition of the hormone cannot negate the toxicity caused by EDTA. In terms of calcium peroxide, due to quick release of oxygen in water, this study fails to apply calcium peroxide to the water culture experiment.

When the pot culture experiment is used to examine the influence of hormones at different concentration levels on the growth of sunflowers, GA₃ 10^-8 M is reported to have the optimal effectiveness, followed by IAA 10^-8 M; IAA 10^-12 M has the lowest effectiveness. According to an accumulation analysis of heavy metals at different levels, GA₃ concentrates in leaves to transport nutrition in soil to leaves. This results in an excellent TF value of 2.329G of GA₃ than 1.845 of the control group indicating that the addition of the hormone and chelating agent to GA₃ increases the TF value and the chelating agent is beneficial to the sunflower plant. If we examine phytoattenuation ability, the one-month experiment was divided into three stages for ten days each. The concentration level of heavy metals in the soil at each stage dropped continuously while that of the control group decreased from 31.63 mg/kg to 23.96 mg/kg, GA₃ from 32.09 mg/kg to 23.04 mg/kg and EDTA from 30.65 mg/kg to 25.93 mg/kg indicating the quickest growth period of the sunflowers from the formation of the bud to blossom. During the stage, the quick upward transportation of nutrition results in quick accumulation of heavy metals; the accumulated speed of heavy metals is found higher than that of directly planted plants. This study shows an improvement in the effectiveness of the addition of hormones on plant extraction and when rehabilitation is incorporated with sunflowers with the beginning bud formation, better treatment effectiveness can be reached.

Distributed biomass energy technology has strong adaptability to the types of raw materials, flexible project scale, can meet the needs of special users, better economy in small scale, easier commercial development, in line with the characteristics of biomass resources and China’s national conditions. The distributed utilization of biomass energy mainly includes biomass briquette fuel and biogas. The key technologies include biomass briquette fuel processing and combustion, large and medium-sized biogas engineering technology, biomass gasification pyrolysis and gas utilization. At present, China’s distributed biomass energy technology is mainly in the stage of technological improvement and application demonstration. It is expected that by 2030, most of the key technologies will be basically mature and have the conditions for industrialization. The main development direction of China’s distributed biomass energy industry is the replacement of traditional coal-fired gas, urban/rural clean living energy supply, and rural ecological environmental protection. The pollution caused by burning coal/fuel oil, and at the same time centering on the national new urbanization strategy, provide sustainable clean energy for the construction of new rural areas, and improve the level of rural ecological and environmental protection. At present, the main bottleneck restricting the development of distributed biomass energy industry is economy and reliability. The state should increase investment in technological innovation and policy support, convert the environmental and social benefits of biomass energy into cost benefits, and promote biomass energy. The development of the industry can be distributed and utilized.

Theoretically, within the diatomic model, the relative stability of most abundant boron clusters B₁₁, B₁₂, and B₁₃ with planar structures in neutral, positive and negative charged-states is studied. According to the specific (per atom) binding energy criterion, B₁₂⁺ (6.49 eV) is found to be the most stable boron cluster, while B₁₁^– + B₁₃⁺ (5.83 eV) neutral pair is expected to present the preferable ablation channel for boron-rich solids. Obtained results would be applicable in production of boron-clusters-based nanostructured coating materials with super-properties such as lightness, hardness, conductivity, chemical inertness, neutron-absorption, etc., making them especially effective for protection against cracking, wear, corrosion, neutron- and electromagnetic-radiations, etc.