The porous carbon/Ni nanoparticle composite was prepared by a freeze-drying method using NaCl as the template. It was applied in the effect of the concentration, adsorption time, and temperature of adsorption on the adsorption behavior. The kinetic model and the adsorption isothermic fitting results show that the adsorption behavior fits with the pseudo-secondary dynamics and the Langmuir isothermal model, indicating that the adsorption process is monolayer adsorption. Thermodynamic results indicate that the adsorption process is spontaneous physicochemical adsorption. The fitting showed that the porous carbon/Ni nanoparticle composites reach 217.17 mg·g^-1, at 313 K indicates good adsorption for Congo red.

Heat removal has become an increasingly crucial issue for microelectronic chips due to increasingly high speed and high performance. One solution is to increase the thermal conductivity of the corresponding dielectrics. However, traditional approach to adding solid heat conductive nanoparticles to polymer dielectrics led to a significant weight increase. Here we propose a dielectric polymer filled with heat conductive hollow nanoparticles to mitigate the weight gain. Our mesoscale simulation of heat conduction through this dielectric polymer composite microstructure using the phase-field spectral iterative perturbation method demonstrates the simultaneous achievement of enhanced effective thermal conductivity and the low density. It is shown that additional heat conductivity enhancement can be achieved by wrapping the hollow nanoparticles with graphene layers. The underlying mesoscale mechanism of such a microstructure design and the quantitative effect of interfacial thermal resistance will be discussed. This work is expected to stimulate future efforts to develop light-weight thermal conductive polymer nanocomposites.

There are numerous studies reported on the usage of the sapindus emarginatus (SE) fruit in cancer and other treatments in the past few years. In this study, crude SE fruit extract was prepared and it was further used to synthesis gold nanoparticles (Au Nps). The synthesized Au Nps were left embedded in the SE fruit extract. The Au Nps embedded in the SE fruit extract (SE-Au Nps) were characterized using UV-Visiable Spectroscopy, Centrifugal Particle Size analyzer (CPS), Scanning Electron Microscope (SEM) and Fourier Transform Infrared Spectroscopy (FTIR). MTT assay was carried out for both SE fruit extract and SE-Au Nps on MCF7 breast cancer cell line and thus compared. The UV-Visible Absorbance for the SE-Au Nps was obtained at 543 nm. The centrifugal particle size analysis of the Au Nps embedded in SE fruit extract showed the size of the nanoparticles to be widely varying with higher fraction of particles between the size ranges of 15 to 20 nm. The morphology of the Au Nps embedded in SE fruit extract was observed using SEM. The presence of Au Nps in SE fruit extract was confirmed using FTIR. The results of the MTT assay on MCF7 breast cancer cell line proved that the % cell viability was less for SE-Au Nps than that of the SE fruit extract alone. Thus, the antiproliferative activity of the SE fruit extract was significantly enhanced by embedding it with Au Nps and it can be effectively used in therapeutic applications after further studies.

Due to its physicochemical properties, nanoparticles titanium dioxide (nTiO₂) is being put into mass production and widespread applications, which inevitably results in their increasing exposure to the water body. After it entering the water body, the chemical properties of nTiO₂ can be influenced by ion compositions, ion strength and pH, which affects their ecological risk. Excess of ammonium (NH₄⁺) fertilizer has contaminated soil and water environments. In this paper, the Zeta potentials and hydrodynamic radius of nTiO₂ were studied in NH₄⁺ solution compared to those in Na⁺ solution. In addition, the sedimentation rate of nTiO₂ was also investigated. The experiment results show that high pH inhibits the sedimentation of nTiO₂. Moreover, NH₄⁺ increases the stability of nTiO₂ more than Na⁺ at the same IS, which was attributed the more negative Zeta potentials and the smaller hydraulic radius. Our results provide a theoretical basis for evaluating the ecological risk of nTiO₂ in aqueous solution containing NH₄⁺.

Branched micro/nano Se was prepared by the redaction of L-Cys•HCl and H₂SeO₃ in hydrothermal method, as β-CD was used as soft template. The structures of products were characterized by SEM, TEM and XRD. Some important factors influencing the morphology of products were studied and discussed, including the amounts of soft template, the reaction temperature and the reaction time. The results showed that external causes had a potent effect on the morphology of micro/nano Se. The uniform branched micro/nano Se prepared under the optimal reaction condition was rhombohedral trigonal selenium t-Se⁰, but its crystallinity degree was low.

The Cu_2–xSe nanoparticles were synthesized by high temperature pyrolysis, modified with aminated polyethylene glycol in aqueous solution and loaded with compound 2,2′–azobis[2–(2–imidazolin–2–yl)propane] dihydrochloride (AIPH). The obtained nanomaterials can induce photothermal effect and use heat to promote the generation of toxic AIPH radicals under the irradiation of near-infrared laser (808 nm), which can effectively kill cancer cells. A series of in vitro experiments can preliminarily prove that Cu_2–xSe–AIPH nanomaterials have strong photothermal conversion ability, good biocompatibility and anticancer properties.