This work aimed to evaluate the effects of using three different substrates in the semi-hydroponic culture of lettuce (Lactuca sativa L.) using two different nutrient solutions. A first trial was performed with a nutrient solution rich in macronutrients and micronutrients suitable for lettuce culture, and a second trial with a nutrient solution with pretreated wastewater from effluents of a cheese factory. The experimental design was in randomized blocks with three repetitions and three substrates were used: perlite, coconut fiber, and expanded clay, in both trials. The following parameters were observed: number of leaves, diameter of the cabbage, fresh and dry weight of the aerial part, chlorophyll index and mineral composition of the lettuce. For the first trial, the highest result for the number of leaves (20 leaves), fresh weight (142.0 g) and dry weight (7.2 g) of the aerial part was obtained in the plants growing on perlite. In the second trial, the highest result for the number of leaves (28 leaves), diameter of cabbage (26.7 cm), fresh weight (118.8 g) and dry weight (9.5 g) of the aerial part were achieved by the plants that were grown in coconut fiber. The nutrient solutions were analyzed after each irrigation cycle to verify the possibility of their discharge into the environment. Several parameters were analyzed: pH, conductivity, redox potential, nitrates, nitrites, ammoniacal nitrogen, chlorides, hardness, calcium, phosphates, sodium, potassium, chemical oxygen demand (COD) and magnesium. Ammoniacal nitrogen was found to be the only nutrient that can limits the discharge of nutrient solutions into the environment. It was also proven that the plants, besides obtaining the nutrients necessary for their development in the semi-hydroponic system with the nutrient solution with pre-treated residual water, also functioned as a purification system, allowing the said nutrient solution to be discharged into the environment at the end of each cycle.

The regularity and variability of the composition distribution of the pyrolysis products of corn stover fermentation residue and phenolic resin with the pyrolysis temperature were investigated by thermogravimetry (TG) and lyser-gas/mass spectrometer (Py-GC/MS). The results show that toluene, phenol and methyl phenol are the main common components of the two systems, 2,3-dihydrobenzofuran, alkoxy compounds and a small amount of carboxylic acid are the unique components in the pyrolysis products of corn straw fermentation residue, while dimethyl phenol, 9H-xanthene and other components in the phenolic. This is a reflection of the differences in the composition and structure of the two raw materials.

Arbuscular mycorrhizal fungi (AMF) increase the uptake of soluble phosphates, while phosphorus solubilizing fungi (S) promote the solubilization of insoluble phosphate complexes, together benefiting plant nutrition. The use of these organisms in combination with minerals or rocks that provide nutrients is another alternative to maintain crop productivity. The objective of this work was to combine AMF and S with pyroclastic materials (ashes and pumicites) from the Puyehue volcano and phosphoric rocks (PR) from the Río Chico Group (Chubut) and to evaluate the performance of these mixtures as substrates for potted production of Lactuca sativa. To formulate the substrates, a mixture of Ter-rafertil® with ashes was used as a base. Penicillium thomii was the S and spores of the fungus Rhizophagus intraradices (AEGIS® Irriga) served as the source of AMF. Various combinations of microorganisms and the addition or not of RP were evaluated. The treatments were: (1) substrate; (2) substrate + AMF; (3) substrate + S; (4) substrate + AMF + S; (5) substrate: PR; (6) substrate: PR + AMF; (7) substrate: PR + S, and (8) substrate: PR + AMF + S. There were 3 replicates per treatment. The parameters evaluated were total and assimilable P content in the substrate, P in plant tissue and dry biomass. All of them were significantly higher in the plants grown in the substrate added with PR and inoculated with S and AMF. This work confirms that the S/AMF combination with volcanic ashes from Puyehue and PR from Grupo Río Chico formulated with a commercial substrate promote the growth of L. sativa. Thus, it is possible to increase the added value of geomaterials of national origin.

In this paper, a classification of low-dimensional nanomaterials is given, and new type of these nanomaterials — subnanophase coatings are proposed. Experimental results on the formation of a wetting layer of a transition metal on a silicon substrate by physical deposition in vacuum and results of this layer identification by the EELS method are given. Based on these results, a new approach to the formation of subnanophase coatings has been proposed by creation of an interface stresses structuring WL. The possible properties and application prospects of subnanophase coatings are considered.

Important modifications are occurring in temperate forests due to climate change; in polar latitudes their distribution area is increasing, while in tropical latitudes it is decreasing due to temperature increase and droughts. One of the biotic regulators of temperate forests are the debarking insects that cause the mortality of certain trees. These insects have increased in number, favored by climate change, and the consequences on forests have not been long in coming. In recent times in the northern hemisphere, the massive mortality of conifers due to the negative synergy between climate change and debarking insects has been evident. In Mexico, we have also experienced infestations by bark stripping insects never seen before; therefore, we are trying to understand the interactions between climate change, forest health and bark stripping insects, to detect the areas with greater susceptibility to attack by these insects and propose management measures to reduce the effects.

The analysis of the accumulation and export of nutrients by the cowpea crop is fundamental for a more sustainable fertilization program, because the definition of the doses of organic fertilizers based only on the estimated maximum yield does not guarantee the maintenance of soil fertility. The objective of this study was to evaluate the effect of fertilization with chicken manure on the productivity, accumulation and exportation of nutrients by the pods of cowpea. A randomized block design was used, with five doses of chicken manure (0; 5; 10; 20 and 40 t ha^-1) and four repetitions. The highest levels of P and Mg were found in the leaves with the application of 40 t ha^-1 of manure. The maximum pod length was 14.47 cm, estimated with the dose of 33.33 t ha^-1 of manure. The highest values of diameter, number of pods per plant and pod productivity were observed at the highest dose of manure applied. In relative terms, that is, total exported in relation to the total extracted by the aerial part, phosphorus is the nutrient most exported by the pods, on average 58%, followed by N (55%), K (43%), Mg (40%), S (38%) and Ca (17%). At the highest dose, although Ca accumulation occurred in large quantities (31.3 kg ha^-1), only 13% of it was exported by the pods. Fertilizing cowpea with chicken manure supplied essential nutrients and increased pod yield from 7.2 (no fertilization) to 16.3 t ha^-1 (fertilization with 40 t ha^-1 of chicken manure). The plant remains of the cowpea constitute an important source of nutrients, being obtained at the highest dose of manure applied (40 t ha^-1) the following amounts of macronutrients (kg ha^-1): N (51.4); P (5.1); K (27.6); Ca (27.1); Mg (8.2); S (5.1), which may return to the soil, with the incorporation of the plants.