Theoretically, within the diatomic model, the relative stability of most abundant boron clusters B₁₁, B₁₂, and B₁₃ with planar structures in neutral, positive and negative charged-states is studied. According to the specific (per atom) binding energy criterion, B₁₂⁺ (6.49 eV) is found to be the most stable boron cluster, while B₁₁^– + B₁₃⁺ (5.83 eV) neutral pair is expected to present the preferable ablation channel for boron-rich solids. Obtained results would be applicable in production of boron-clusters-based nanostructured coating materials with super-properties such as lightness, hardness, conductivity, chemical inertness, neutron-absorption, etc., making them especially effective for protection against cracking, wear, corrosion, neutron- and electromagnetic-radiations, etc.

Arbuscular mycorrhizal fungi (AMF) increase the uptake of soluble phosphates, while phosphorus solubilizing fungi (S) promote the solubilization of insoluble phosphate complexes, together benefiting plant nutrition. The use of these organisms in combination with minerals or rocks that provide nutrients is another alternative to maintain crop productivity. The objective of this work was to combine AMF and S with pyroclastic materials (ashes and pumicites) from the Puyehue volcano and phosphoric rocks (PR) from the Río Chico Group (Chubut) and to evaluate the performance of these mixtures as substrates for potted production of Lactuca sativa. To formulate the substrates, a mixture of Ter-rafertil® with ashes was used as a base. Penicillium thomii was the S and spores of the fungus Rhizophagus intraradices (AEGIS® Irriga) served as the source of AMF. Various combinations of microorganisms and the addition or not of RP were evaluated. The treatments were: (1) substrate; (2) substrate + AMF; (3) substrate + S; (4) substrate + AMF + S; (5) substrate: PR; (6) substrate: PR + AMF; (7) substrate: PR + S, and (8) substrate: PR + AMF + S. There were 3 replicates per treatment. The parameters evaluated were total and assimilable P content in the substrate, P in plant tissue and dry biomass. All of them were significantly higher in the plants grown in the substrate added with PR and inoculated with S and AMF. This work confirms that the S/AMF combination with volcanic ashes from Puyehue and PR from Grupo Río Chico formulated with a commercial substrate promote the growth of L. sativa. Thus, it is possible to increase the added value of geomaterials of national origin.

Based on the population change data of 2005–2009, 2010–2014, 2015–2019 and 2005–2019, the shrinking cities in Northeast China are determined to analyze their spatial distribution pattern. And the influencing factors and effects of shrinking cities in Northeast China are explored by using multiple linear regression method and random forest regression method. The results show that: 1) In space, the shrinking cities in Northeast China are mainly distributed in the “land edge” areas represented by Changbai Mountain, Sanjiang Plain, Xiaoxing’an Mountain and Daxing’an Mountain. In terms of time, the contraction center shows an obvious trend of moving northward, while the opposite expansion center shows a trend of moving southward, and the shrinking cities gather further; 2) in the study of influencing factors, the results of multiple linear regression and random forest regression show that socio-economic factors play a major role in the formation of shrinking cities; 3) the precision of random forest regression is higher than that of multiple linear regression. The results show that per capita GDP has the greatest impact on the contraction intensity, followed by the unemployment rate, science and education expenses and the average wage of on-the-job workers. Among the four influencing factors, only the unemployment rate promotes the contraction, and the other three influencing factors inhibit the formation of shrinking cities to various degrees.

The analysis of the accumulation and export of nutrients by the cowpea crop is fundamental for a more sustainable fertilization program, because the definition of the doses of organic fertilizers based only on the estimated maximum yield does not guarantee the maintenance of soil fertility. The objective of this study was to evaluate the effect of fertilization with chicken manure on the productivity, accumulation and exportation of nutrients by the pods of cowpea. A randomized block design was used, with five doses of chicken manure (0; 5; 10; 20 and 40 t ha^-1) and four repetitions. The highest levels of P and Mg were found in the leaves with the application of 40 t ha^-1 of manure. The maximum pod length was 14.47 cm, estimated with the dose of 33.33 t ha^-1 of manure. The highest values of diameter, number of pods per plant and pod productivity were observed at the highest dose of manure applied. In relative terms, that is, total exported in relation to the total extracted by the aerial part, phosphorus is the nutrient most exported by the pods, on average 58%, followed by N (55%), K (43%), Mg (40%), S (38%) and Ca (17%). At the highest dose, although Ca accumulation occurred in large quantities (31.3 kg ha^-1), only 13% of it was exported by the pods. Fertilizing cowpea with chicken manure supplied essential nutrients and increased pod yield from 7.2 (no fertilization) to 16.3 t ha^-1 (fertilization with 40 t ha^-1 of chicken manure). The plant remains of the cowpea constitute an important source of nutrients, being obtained at the highest dose of manure applied (40 t ha^-1) the following amounts of macronutrients (kg ha^-1): N (51.4); P (5.1); K (27.6); Ca (27.1); Mg (8.2); S (5.1), which may return to the soil, with the incorporation of the plants.

One functional class is described in terms of one-sided modulus of continuity and the modulus of positive (negative) variation on which there
is a uniform convergence of the truncated cardinal Whittaker functions.

Quartz sand was used as bed material in a small fluidized bed reactor with 1 kg/h feed. Corn straw powder with particle size of 20–40 mesh, 40–60 mesh, 60–80 mesh and 80–120 mesh was used as raw material for rapid pyrolysis at reaction temperatures of 400 °C, 450 °C, 500 °C and 550 °C. The bio-oil obtained after liquefaction of pyrolysis gas was analyzed. The variation trend of bio-oil composition in pyrolysis of corn straw powder with different reaction temperatures and raw material sizes was compared. The results show that: (1) the content of 3-hydroxyl-2-phenyl-2-acrylic acid in bio-oil increases with the decrease of raw material particle size, but it is less at 450 °C; (2) with the increase of reaction temperature, the content of hydroxyacetaldehyde in bio-oil increases at first and then decreases: the content of hydroxyacetaldehyde in bio-oil is the highest at 500 °C when the particle size is 20–40 mesh, and the highest at 450 °C with the other three particle sizes. Compared with other particle sizes, raw material with the particle size of 60–80 mesh is not conducive to the formation of aldehyde compounds; (3) the reaction temperature of 500 °C and the particle size of 60–80 mesh of raw materials are more conducive to the formation of phenolic compounds in bio-oil; (4) the ester compounds with particle size of 20–40 mesh in bio-oil is 20% higher than that of other particle sizes; (5) the reaction temperature and the particle size of raw materials had no significant effect on the formation of ketones, alcohols and alkane compounds in bio-oils.