The US Infrastructure Investment and Job Act (IIJA), also commonly referred to as the Bipartisan Infrastructure Bill, passed in 2021, has drawn international attention. It aims to help to rebuild US infrastructure, including transportation networks, broadband, water, power and energy, environmental protection and public works projects. An estimated $1.2 trillion in total funding over ten years will be allocated. The Bipartisan Infrastructure Bill is the largest funding bill for US infrastructure in the recent history of the United States. This review article will specifically discuss funding allocations for roads and bridges, power and grids, broadband, water infrastructure, airports, environmental protection, ports, Western water infrastructure, electric vehicle charging stations and electric school buses in the new spending of the Infrastructure Investment and Job Act and why these investments are urgently necessary. This article will also briefly discuss the views of think tank experts, the public policy perspectives, the impact on domestic and global arenas of the new spending in the IIJA, and the public policy implications.

Climate and vegetation are variables of the physical space that have a dynamic and interdependent relationship. Flora modifies climatic elements and gives rise to a microclimate whose characterization is a function of regional climatic conditions and vegetation structure. The objective of this work was to compare the climatic variations (inside and outside) of the Caldén Forest in the Parque Luro Provincial Reserve. Temperature, relative humidity, wind speed, wind direction and precipitation data from two meteorological stations for 2012 were analyzed and statistically compared. The influence of the forest on climatic parameters was demonstrated and it was found that the greatest variations were in wind speed, daily temperature and precipitation.

The heat collection evaporator was modeled based on equilibrium homogeneous theory, and the Runge-Kutta calculation method was used to analyze and solve the flow in the heat collection evaporator. The influence of environmental factors such as solar irradiance, ambient temperature and wind speed on the variation of refrigerant pressure in two kinds of heat collecting evaporator was analyzed under the set working conditions. The results show that the solar energy irradiance has a great influence on the pressure drop in the tube of serpentine heat collecting evaporator, and the maximum pressure drop of the refrigerant in the tube is 16.3%, minimum pressure drop is 7.8%. However, it has little influence on the pressure drop of the tube sheet evaporator. The maximum pressure drop in the refrigerant tube of the tube sheet evaporator is 4.8%, minimum pressure drop is 1.8%. When the irradiance reaches 800 W/m², the refrigerant in the serpentine-tube evaporator has been completely vaporized at 6 m, it’s completely vaporized at 3 m.

Seawater desalination has been studied with interest due to the scarcity of fresh water for human consumption. Solar distillation is an old method; the productivity, energy consumption of the process and the cost of the desalinated water thus obtained depend on the efficiency achieved in each of the stages of these systems. The limited capacity to absorb solar radiation and transform it into useful heat for evaporation, interaction with the surrounding medium, and heat losses restrict the overall efficiency of the thermal process and productivity. Since the energy comes from solar radiation, the maximum productivity of this process will be constrained by the magnitude of the total solar radiation available in an area of the planet due to its geographic location, time of year and local climatic conditions. The processes of this energy will be thermodynamically limited by the heat transfer coefficients achieved in the equipment, the maximum value that the evaporation heat can reach, as long as the losses to the environment by convection and radiation are minimal. Comparative analyses of several proposed models, reported data of distillers, reported data of solar radiation that reach average values of up to 7.2–7.4 kwh/m² in some regions of the planet are presented and estimates are made for productivity of these equipments that they reach between 6.7 and 6.9 kg/m² day with a theoretical maximum efficiency of about 0.16 of the total solar radiation.

Many questions of control theory are well studied for systems which satisfy to the relative degree definition. If this definition is fulfilled then there exists linear state-space transform reducing system to a very convenient canonical form where zero dynamics is a part of system’s equations. Algorithms of such reduction are well-known. However, there exist systems which don’t satisfy this definition. Such systems are the subject of investigation in the presented paper. To investigate their properties here we suggest to consider an analogue of the classical relative degree definition – the so-called column-wise relative degree. It turned out that this definition is satisfied in some cases when classical relative degree doesn’t exist. We introduce this notion here, investigate it properties and suggest algorithm for reducing systems to the column-wise relative degree compliant form if possible. It is possible to show that systems with column-wise relative degree also can be reduced to a convenient canonical form by a linear state-space transformation. Some problems arise from the fact that some systems which do not have relative degree can be reduced to a form with it using linear inputs or outputs transform. Here we show that this is an interesting mathematical problem, which can be solved with the help of properties of relative degree, formulated and proved in this paper.

Banana macropropagation in a thermal chamber is an economical technology, effective as a phytosanitary cleaning method, and efficient to enhance seedling production. The objective of this work was to evaluate the effects of corm size (CS) and benzylaminopurine (BAP) on plantain cv. Barraganete seedling proliferation in two propagation environments (PE). The treatments consisted of two levels of BAP (with and without BAP), three CS (2 ± 0.5, 4 ± 0.5 and 6 ± 0.5 kg) and two PE (thermal chamber and raised bed). The variables evaluated were sprouting time (days), multiplication rate (MT) per unit (seedlings per corm) and area (seedlings per m²). Sprouting time was significantly influenced (p < 0.05) by the PE, where the thermal chamber advanced shoot emergence by 12 days, with respect to the raised bed. MT of seedlings per corm and m², were significantly influenced (p < 0.05) by BAP × AP and TC × AP interactions, where the highest seedling production per corm occurred inside thermal chamber with BAP and 6 ± 0.5 kg corms, while seedling production per m² was higher with 2 ± 0.5 kg corms under the same thermal chamber conditions and with BAP. The main effects results reported that with BAP there were 30 and 31% increases in MT per corm and per m², respectively, relative to the treatment without BAP. Within the thermal chamber the MT per corm and per m² increased by 44% relative to the raised bed. Regarding the effect of CS, larger corms achieved higher individual MT, while smaller corms achieved higher MT per area. The use of a thermal chamber and BAP is recommended for mass production of banana seedlings through macropropagation.