The present study assessed the potential of sediment loading in Beteni, Lauruk, Andheri, and Harpan sub-watersheds of Phewa Lake and estimated the sediment yield in the year 2020. Morphometry, land use/land cover, geology, climate, and human and development factors of the sub-watersheds were studied to assess the potential of sediment loading in the sub-watersheds. SRTM DEM was used for the computation of morphometric parameters and land use/land cover maps were prepared by using Landsat imagery. Geology, rainfall data, census data, and road maps were collected from various secondary sources. The sediment yields of the four sub-watersheds in the year 2020 were estimated by measuring the sediment volume deposited in the sediment retention ponds at the outlet of each sub-watershed. Results indicated that Beteni had the highest potential for sediment loading, while Harpan had the lowest. Likewise, the sediment yields for Beteni, Lauruk, Andheri, and Harpan sub-watersheds in 2020 were estimated at 1,420.67 m³/km²/year, 2,280.14 m³/km²/year, 1,666.77 m³/km²/year, and 766.42 m³/km²/year, respectively. To reduce sedimentation in Phewa Lake, it is recommended to regularly maintain siltation dams and construct check dams along the drainage slopes, alongside other soil conservation measures and appropriate land use practices in the upstream areas of the sub-watersheds.

The study focused on investigating the effects of varying levels of HA (HA₁ = 0, HA₂ = 25, HA₃ = 50, HA₄ = 75, and HA₅ = 100) on Red Dragon, Red Prince, and Red Meat varieties of red radish. This analysis aimed to unravel the relationship between different levels of HA and their impact on the growth and productivity of red radish genotypes. The findings revealed that the Red Prince genotype attained the utmost plant height of 24.00 cm, an average of 7.50 leaves per plant, a leaf area of 23.11 cm², a canopy cover of 26.76%, a leaf chlorophyll content of 54.60%, a leaf fresh weight of 41.16 g, a leaf dry weight of 8.20 g, a root length measuring 9.73 cm, a root diameter of 3.19 mm, a root fresh weight of 27.60 g, a root dry weight of 6.75 g, and a remarkable total yield of 17.93 tons per hectare. The implications of this study are poised to benefit farmers within the Dera Ismail Khan Region, specifically in the plain areas of Pakistan, by promoting the cultivation of the Red Prince variety.

Ancient Minipe Anicut, Sri Lanka is world-famous for its engineering excellence. Due to its importance, conserving the ancient anicut, another anicut was constructed downstream in the 20th century. Nevertheless, the water diverted from the ancient anicut to the Minipe Left Bank (LB) Canal was kept as it was due to inherited agricultural importance. This research focuses on studying the contributions made by the adjacent catchment along the Minipe LB Canal. There are several level crossings along the Minipe Left Bank Canal from which the runoff of the local catchment flow into the Minipe LB Canal. Hydrologic Modeling System (HEC-HMS) is used to obtain the yield from each catchment into the Canal, which was compared with the annual diversions from Minipe anicut. The total yield from each stream has been compared with the annual diversion of the Minipe LB Canal from 2014 to 2020. The results obtained from this study reveal that there is sufficient water available for water augmentation in the basin, with an estimated annual average cumulative yield from the catchment of 453.6 MCM. This cumulative yield is 1.7 times the annual average diversion from the Mahaweli River, which is 271.9 MCM. With the findings, it is concluded that there is a potential to augment water from the catchment to address pertaining water shortages conveyance in the command area.

Kinnow production is hampered due to the lack of micronutrient applications such as zinc (Zn), iron (Fe), and manganese (Mn), which play a significant role in the metabolic activities of the plant, affecting yield and quality. The farmers of the region use mineral micronutrient fertilizers, but it leads to phytotoxicity due to unoptimized fertilizer application dose. In the present investigation, an attempt has been made to optimize the Zn, Mn, and Fe minerals dose as tank mix foliar application for improvement of fruit yield, quality, and uptake of nutrients. The twelve combinations of different doses of zinc sulphate, manganese sulphate, and ferrous sulphate fertilizers replicated three times were tested at kinnow orchards established at Krishi Vigyan Kendra, Bathinda, Punjab, India. The data revealed that the fruit drop was significantly low in the treatment F₁₂ (43.4%) (tank mix spray of 0.3% ZnSO₄ + 0.2% MnSO₄ + 0.1% FeSO₄ ) compared to control treatment. The fruit yield per tree was significantly higher in the treatment F12 compared to untreated control. The juice percentage was also recorded higher in treatment F12 as compared to control, and the juice percentage improved by 2.6%. The leaf nutrient analysis also revealed translocation of higher amount of nutrient from leaf to fruit under optimized supply of micronutrient. Thus, the application of tank mix spray of 0.3% ZnSO₄ + 0.2% MnSO₄ + 0.1% FeSO₄ may be used for better fruit yield and quality.

Highly nutritive and antioxidants-enriched okra (Abelmoschus esculentus) gets sub-optimal field yield due to the irregular germination coupled with non-synchronized harvests. Hence, the research aimed at assessing the combined impact of seed priming and field-level gibberellic acid (GA₃) foliar spray on the yield and post-harvest quality of okra. The lab studies were conducted using a complete randomized design (CRD), while the field trials were performed following a factorial randomized complete block design (RCBD) with three replications. Okra seeds were subjected to ten different priming methods to assess their impact on seed germination and seeding vigor. In the premier step, okra seeds were subjected to ten different priming methods, like hydro priming for 6, 12, and 18 h, halo priming with 3% NaCl at 35 ℃, 45 ℃, and 60 ℃, acid priming with 80% H₂SO₄ for 2.5, 5, and 10 min. Based on the observation, hydro priming for 12 h exhibited the best germination rate (90%), followed by halo seed priming at 60 ℃ and acid priming for 5 min. Furthermore, the halo priming at 60 ℃ demonstrated the greatest seedling vigor index (1965), whereas acid priming for 5 min resulted in favorable outcomes in terms of early emergence in 2.66 days. In addition, varying concentrations of GA₃ (0, 100, 200, and 300 ppm) were also administered to the best three primed seedlings for evaluating their field performance. The findings indicated that applying GA₃ at a concentration of 300 ppm to seedlings raised through acid priming (80% H₂SO₄ for 5 min) resulted in improved leaf length, reduced time to flowering (first and 50%) and harvest, increased pod diameter, individual pod weight, and yield per plant (735.16 g). Additionally, the treatment involving GA₃ at 300 ppm with halo priming (3% NaCl) at 60 ℃ exhibited the longest shelf life (21 days) of okra with the lowest levels of rotting (6.73%) and color change (1.12) in the polyethylene storage condition.

Twenty-two tomato (Solanum lycopersicum L.) genotypes were examined for correlation and path analysis in the randomized block design under open field conditions. Total fruit yield showed a significant positive correlation with the number of fruits per plant, average fruit weight, lycopene content, and percent seedling survival in the field at both the genotypic and phenotypic levels. A strong correlation between these characters revealed that selection based on these characters would consequently improve the total fruit yield. Path analysis showed that the number of fruits per plant, average fruit weight, percent seedling survival in the nursery, and number of locules per fruit exhibited high positive direct phenotypic effects on total fruit yield, whereas the number of fruits per plant, average fruit weight, percent seedling survival in the field, and pollen viability had very high positive direct genotypic effects. Therefore, to increase the yield, it would be profitable to prioritize these traits in the selection program.