The development status of flat panel solar water heater and the composition of water heater are described. The solar radiation in three typical weather conditions of sunny, cloudy and rainy days is studied. The hot water temperature, heat and heat collector efficiency are studied. The results show that the influence of the weather on the solar irradiance is large, and the irradiance has a great influence on the water temperature.

In the current era, electromagnetic radiation is everywhere. Every day electromagnetic radiation and static electricity caused by a variety of hazards. So, anti-electromagnetic radiation and anti-static awareness gradually enjoys popular support, more attention are gained by people on the anti-electromagnetic radiation and anti-static. This caused radiation protection and anti-static clothing industry’s rise by the day. Radiation protection and anti-static clothing will enter various households to provide a certain amount of protection to the people's health. We discuss two parts in this paper, specifically from the effects of the electromagnetic radiation and electrostatic effects which started on radiation clothing and anti-static clothing. The main contents of this paper are as follows: The first part of the definition of electromagnetic radiation and its brief introduction, while explaining the types of electromagnetic radiation and electromagnetic radiation sources in daily lives, followed by the emphasis of serious harms on electromagnetic radiation on human health It is precisely because of electromagnetic radiation on people's lives have serious threat, that makes the development of radiation protection. This follows the basic introduction of the radiation suit and the development of radiation protection clothings. The development of radiation protection suits is an established industry. Materials made of radiation protection are constantly changing, but their basic working principle has not changed. Followed by the introduction of the basic principles of radiation protection clothings, we theoretically present specific analysis and demonstration. However, the theoretical analysis and practice is often consists a certain gap, so we highlight a few actual situations on the impact of radiation protection clothings. Finally, we present a simple discussion on wide range of applications of radiation protection clothings. The thought process of second part is similar as the first part, respectively, we introduce the health hazards and the impact on people's lives of electrostatic effect and static electricity . Followed by that it is the basic principles, relevant analysis and discussion of anti-static clothing Finally, we provide the detailed explanation of the application of anti-static clothing.

With the increasing demand for sustainable energy, advanced characterization methods are becoming more and more important in the field of energy materials research. With the help of X-ray imaging technology, we can obtain the morphology, structure and stress change information of energy materials in real time from two-dimensional and three-dimensional perspectives. In addition, with the help of high penetration X-ray and high brightness synchrotron radiation source, in-situ experiments are designed to obtain the qualitative and quantitative change information of samples during the charge and discharge process. In this paper, X-ray imaging technology based on synchrotron and its related applications are reviewed. The applications of several main X-ray imaging technologies in the field of energy materials, including X-ray projection imaging, transmission X-ray microscopy, scanning transmission X-ray microscopy, X-ray fluorescence microscopy and coherent diffraction imaging, are discussed. The application prospects and development directions of X-ray imaging in the future are prospected.

The optimized methodology and results of the new characterization in terms of dose and image quality of the X-ray system used in the main pediatric hemodynamics service in Chile are presented. In addition, scattered dose rate values at the operator’s eye level are reported for all acquisition modes available in different thicknesses of absorbent media and angiography. The characterization was performed according to the European DIMOND and SENTINEL protocols adapted to pediatric procedures. The air kerma at the entrance surface (ESAK) was measured and the image quality parameters signal-to-noise ratio (SNR) and a figure of merit (FOM) were calculated. The scattered dose rate was measured in personal dose equivalent units. The ESAK for fluoroscopic modes ranged from 0.2 to 35.6 μGy/image when passing from 4 to 20 cm of polymethyl methacrylate (PMMA). For the cine mode, these values ranged from 2.8 to 160.1 μGy/image. The values of the image quality parameters showed a correct system configuration, although abnormal values were observed in the medium fluoroscopic mode. As for the scattered dose rate at the level of the cardiologist’s eyes, the highest value is PMMA with a thickness of 20 cm, where the cine mode reached 9.41 mSv·h-1. The differences found from previous evaluations can be explained by the deterioration of the system and the change of one of the X-ray tubes.

In Costa Rica, there is no explicit recommendation from the competent authorities for the use of a specific phantom, so experts must explore what suppliers offer, among which the Normi Mam Digital phantom from PTW stands out. This article presents the results of the dosimetry and image quality control applied to the Normi Mam Digital phantom to validate it as equipment that complies with the recommendations of the Human Health Series No. 17. The results obtained were satisfactory, proving that the equipment complies with the tolerances recommended by international health bodies.

In recent years, ghost imaging has made important progress in the field of remote sensing imaging. In order to promote the application of solar ghost imaging in this field, this paper studies the computational ghost imaging based on the incoherent light of blackbody radiation. Firstly, according to the intensity probability density function of blackbody radiation, the expression of contrast-to-noise ratio (R_CN) describing the quality of computational ghost imaging is obtained, and then the random speckle pattern simulating blackbody radiation is generated by computer with the idea of slice sampling, finally, a digital light projector is used to modulate and generate the random modulated light that simulates the blackbody radiation light source, and this light source is used to realize the computational ghost image of the reflective object in the experiment. The “ghost image” of the object under different measurement frame numbers is reconstructed, and the contrast-to-noise ratio describing the imaging quality is measured. The results show that the image quality is relatively good when the average intensity (gray) of the randomly modulated speckle is about 160. On the other hand, the contrast-to-noise ratio of the image gradually increases from 0.8795 to 1.241, 1.516, 1.755, 2.100 and 2.371 as the number of measurement frames increases from 2,000 to 4,000, 6,000, 8,000, 12,000 and 20,000, respectively. The experimental results are basically consistent with the theoretical analysis. The results are of great significance for the application of ghost imaging with incoherent light, such as sunlight, which is approximately regarded as blackbody radiation, in the field of remote imaging.