Four alloys based on niobium and containing about 33wt.%Cr, 0.4wt.C and, in atomic content equivalent to the carbon one, Ta, Ti, Hf or Zr, were elaborated by classical foundry under inert atmosphere. Their as-cast microstructures were characterized by X-ray diffraction, electron microscopy, energy dispersion spectrometry and while their room temperature hardness was specified by Vickers indentation. The microstructures are in the four cases composed of a dendritic Nb-based solid solution and of an interdendritic NbCr₂ Laves phase. Despite the MC-former behavior of Ta, Ti, Hf and Zr usually observed in nickel or cobalt-based alloys, none of the four alloys contain MC carbides. Carbon is essentially visible as graphite flakes. These alloys are brittle at room temperature and hard to machine. Indentation shows that the Vickers hardness is very high, close to 1000HV_10kg. Indentation lead to crack propagation through the niobium phase and the Laves areas. Obviously no niobium-based alloys microstructurally similar to high performance MC-strengthened nickel-based and cobalt-based can be expected. However the high temperature mechanical and chemical properties of these alloys remain to be investigated.

The effects of different storage temperatures (2, 4 and 8 ℃) and their corresponding optimal heat treatment conditions on the quality, physiological and biochemical indexes of Cucumber Fruits during storage were studied by using the quadratic regression orthogonal rotation combination design. The effects of different storage temperatures (2, 4 and 8 ℃) and their corresponding optimal heat treatment conditions on the chilling injury, hardness, weightlessness rate, polyphenol oxidase (PPO), catalase (CAT), peroxidase (POD), H₂O₂, super oxygen anion free radical (O^2-), ASA and GSH were determined. The results showed that heat treatment could inhibit chilling injury, while heat treatment combined with 4 ℃ low temperature storage could effectively inhibit the decline of fruit hardness and weight loss rate, delay the increase of peroxidase (POD) and polyphenol oxidase (PPO) activities, inhibit the increase of H₂O₂ and superoxide anion free radical O^2- and significantly inhibit the browning of cucumber, delay the decline of ascorbic acid and maintain the content of GSH, it was beneficial to adjust the balance of active oxygen system. The results showed that under the storage condition of 4 ℃, the hot water treatment condition of cucumber was 39.4 ℃ and 24.3 min, which could delay the senescence of cucumber fruit and better maintain the quality of cucumber fruit.

We have studied the effect of the series resistance on the heating of the cathode, which is based on carbon nanotubes and serves to realize the field emission of electrons into the vacuum. The experiment was performed with the single multi-walled carbon nanotube (MCNT) that was separated from the array grown by CVD method with thin-film Ni-Ti catalyst (nickel 4 nm/Ti 10 nm). The heating of the cathode leads to the appearance of a current of the thermionic emission. The experimental voltage current characteristic exhibited the negative resistance region caused by thermal field emission. This current increases strongly with increasing voltage and contributes to the degradation of the cold emitter. The calculation of the temperature of the end of the cathode is made taking into account the effect of the phenomenon that warms up and cools the cathode. We have developed a method for processing of the emission volt-ampere characteristics of a cathode, which relies on a numerical calculation of the field emission current and the comparison of these calculations with experiments. The model of the volt-ampere characteristic takes into account the CNT’s geometry, properties, its contact with the catalyst, heating and simultaneous implementation of the thermionic and field emission. The calculation made it possible to determine a number of important parameters, including the voltage and current of the beginning of thermionic emission, the temperature distribution along the cathode and the resistance of the nanotube. The phenomenon of thermionic emission from CNTs was investigated experimentally and theoretically. The conditions of this type emission occurrence were defined. The results of the study could form the basis of theory of CNT emitter’s degradation.