This article identifies the role of anti-corruption legislation in sustainable development. The descriptive approach is used to achieve the research objectives, as it is the appropriate scientific method suitable for the nature of the study subject in terms of presenting information related to combating administrative corruption. The results indicate that efforts to combat administrative corruption to achieve sustainable development in countries can only be achieved through strict legislation specialized in combating administrative corruption with the activation of accountability mechanisms in all state departments, bodies, and ministries. The results also demonstrate the alignment of the national and international efforts to reduce the phenomenon of corruption through international agreements and treaties. Towards the end, key conclusions and recommendations are also appropriately incorporated.

This work evaluates the physical and physical-chemical parameters of the strawberry variety “Festival”, obtained in the soil and climate conditions of Humpata, Huila Province, Angola, following the transformation into sweet of adequate quality. The analyses made were: the mass determined on an analytical balance and the transversal and longitudinal diameters with a pachymeter. Other analyses were: total titratable acidity by volumetry, pH by potentiometry, total soluble solids by refractometry, moisture and ash by gravimetry. The study showed that the pH of the pulp was 3.41; and in the candy it was 3.31. The titratable acidity in the strawberry pulp had a value of 0.186 g/100 mL and in the jam 0.096 g/100 mL; the ascorbic acid content in the pulp was 18.60 mg∕100 g. The average soluble solids content in the pulp was 9.51 °Brix and for the jam 68.83 °Brix. These chemical characteristics of the pulp and jam provide information about their nutritional values.

Cardiovascular imaging analysis is a useful tool for the diagnosis, treatment and monitoring of cardiovascular diseases. Imaging techniques allow non-invasive quantitative assessment of cardiac function, providing morphological, functional and dynamic information. Recent technological advances in ultrasound have made it possible to improve the quality of patient treatment, thanks to the use of modern image processing and analysis techniques. However, the acquisition of these dynamic three-dimensional (3D) images leads to the production of large volumes of data to process, from which cardiac structures must be extracted and analyzed during the cardiac cycle. Extraction, three-dimensional visualization, and qualification tools are currently used within the clinical routine, but unfortunately require significant interaction with the physician. These elements justify the development of new efficient and robust algorithms for structure extraction and cardiac motion estimation from three-dimensional images. As a result, making available to clinicians new means to accurately assess cardiac anatomy and function from three-dimensional images represents a definite advance in the investigation of a complete description of the heart from a single examination. The aim of this article is to show what advances have been made in 3D cardiac imaging by ultrasound and additionally to observe which areas have been studied under this imaging modality.

Simple mathematical expressions are given for the betweenness centrality of nodes in trees, forests and cycles. As application, a centrality test is given for when a network might be a forest.

The micro staring hyperspectral imager can simultaneously acquire two spatial and one spectral images, and only record the external orientation elements of the entire hyperspectral image rather than the external orientation elements of each frame of the image, which avoids the geometric instability during scanning, effectively solves the problem of large geometric deformation of the small line scanning hyperspectral imager, and is suitable for the small UAV load platform with unstable attitude. At present, most of the research focuses on the radio-metric correction method of line scan hyperspectral imager. The application time of staring hyperspectral imager is short, and there is no mature data processing re-search at home and abroad, which hinders the application of UAV micro staring hyperspectral imaging system. In this paper, the calibration method of the linearity and variability of the radiation response of the micro staring hyperspectral imager on the UAV is studied, and the effectiveness of this method is quantitatively evaluated. The results show that the hyperspectral image has obvious vignetting effect and strip phenomenon before the correction of radiation response variability. After the correction, the radiation response variation coefficient of pixels in different bands decreases significantly, and the vignetting effect and image strip decrease significantly. In this paper, a multi-target radiometric calibration method is proposed, and the accuracy of radiometric calibration is verified by comparing the calibrated hyperspectral image spectrum with the measured ground object spectrum of the ground spectrometer. The results show that the calibration results of the multi-target radiometric calibration method show better results, especially for the near-infrared band, and the difference with the surface reflectance measured by the spectrometer is small.

The present research is on the propagation of Rayleigh waves in a homogenous thermoelastic solid half-space by considering the compact form of six different theories of thermoelasticity. The medium is subjected to an insulated boundary surface that is free from normal stress, tangential stress, and a temperature gradient normal to the surface. After developing a mathematical model, a dispersion equation is obtained with irrational terms. To apply the algebraic method, this equation must be converted into a rational polynomial equation. From this, only those roots are filtered out, which has satisfied both of the above equations for the propagation of waves decaying with depth. With the help of these roots, different characteristics are computed numerically, like phase velocity, attenuation coefficient, and path of particles. Various particular cases are compared graphically by using phase velocity and attenuation coefficient. The elliptic path of surface particles in Rayleigh wave propagation is also presented for the different theories using physical constants of copper material for different depths and thermal conductivity.