As an important ecosystem type in the coastal zone, mangroves have important ecological functions, such as maintaining coastal biodiversity, preventing wind and consolidating the coast, promoting silt and building land. It is of great significance to understand the protected status of mangroves in the context of climate change and rapid urbanization. Based on the mangrove classification data from remote sensing interpretation, through vacancy analysis, the in-situ protection status of mangroves in China is analyzed. The results show that the total area of mangroves distributed in China is 264 km² (excluding the statistical data of Hong Kong, Macao and Taiwan), of which 61.4% are protected in natural reserves. In terms of the main provinces where mangroves are distributed, the mangrove area distributed in Hainan Province is small but the protection proportion is high, while the mangrove area distributed in Guangxi and Guangdong Province is large but the proportion of protected areas is relatively low. Among the three mangrove types, Rhizophora apiculate-Xylocarpus granatum and Rhizophora stylosa-Bruguiera gymnorrhiza had high proportions (>90%) covered by reserves, but relatively small areas. In contrast, Kandelia candel-Aegiceras corniculatum-Avicennia marina had relatively low reserve coverage (52.6%), but a large area. The study puts forward the key areas of mangrove distribution outside the nature reserve, and suggests that they should be protected by delimiting ecological protection red lines.

The importance of improving industrial transformation processes for more efficient ones is part of the current challenges. Specifically, the development of more efficient processes in the production of biofuels, where the reaction and separation processes can be intensified, is of great interest to reduce the energy consumption associated with the process. In the case of Biodiesel, the process is defined by a chemical reaction and by the components associated to the process, where the thermochemical study seeks to develop calculations for the subsequent understanding of the reaction and purification process. Thus, the analysis of the mixture of the components using the process simulator Aspen Plus V9^® unravels the thermochemical study. The UNIFAC-DMD thermodynamic method was used to estimate the binary equilibrium parameters of the reagents using the simulator. The analyzed aspects present the behavior of the components in different temperature conditions, the azeotropic behavior and the determined thermochemical conditions.

Aiming at the current problems of poor dynamic reconstruction of UAV aerial remote sensing images and low image clarity, the dynamic reconstruction method of UAV aerial remote sensing images based on compression perception is proposed. Construct a quality reduction model for UAV aerial remote sensing images, obtain image feature information, and further noise reduction preprocessing of UAV aerial remote sensing images to better improve the resolution, spectral and multi-temporal trends of UAV aerial remote sensing images, and effectively solve the problems of resource waste such as large amount of sampled data, long sampling time and large amount of data transmission and storage. Maximize the UAV aerial remote sensing images sampling rate, reduce the complexity of dynamic reconstruction of UAV aerial remote sensing images, and effectively obtain the research requirements of high-quality image reconstruction. The experimental results show that the proposed dynamic reconstruction method of UAV aerial remote sensing images based on compressed sensing is correct and effective, which is better than the current mainstream methods.

In order to explore the influence of the ferroelectric surface on the structure and properties of semiconductor oxides, the growth of CdS nanocrystals was regulated and controlled by taking single-crystal perovskite PbTiO₃ nanosheets as the substrate through a simple hydrothermal method. Through composition design, a series of PbTiO₃-CdS nanocomposite materials with different loading concentrations were prepared, and their microstructure and photocatalytic properties were systematically analyzed. Studies show that in the prepared product, CdS nanoparticles selectively grow on the surfaces of PbTiO₃ nanosheets, and their morphology is affected by the exposed surfaces of PbTiO₃ nanosheets. There is a clear interface between the PbTiO₃ substrate and CdS nanoparticles. The concentration of the initial reactant and the time of hydrothermal reaction also significantly affect the crystal morphology of CdS. Photocatalysis studies have shown that the prepared PbTiO₃-CdS nanocomposite material has a significant degradation effect on 10 mg/L of Rhodamine B aqueous solution. The degradation efficiency rises with the increase of CdS loading concentration. When degrading 10 mg/L Rhodamine B aqueous solution, the PbTiO₃-CdS sample with a mass fraction of 3% can reach a degradation rate of 72% within 120 min.