With the improvement of people's living standards, water heaters almost into the various households. In the energy-saving emission reduction has become the trend of the times today, saving energy and reducing carbon emissions is the most fashionable way of life. Air source heat pump water heaters are increasingly being used in people's lives. It is well known that it has many advantages, safety, energy saving, comfort, environmental protection, but there are some factors that affect its development and promotion. This paper mainly discusses the development history of air source heat pump technology at home and abroad, working principle, working flow, turbo technology at present stage, efficient heat exchange, and the research status of air source heat pump technology, such as new type refrigerant and dual frequency compression frequency conversion, then it discusses the application of air source heat pump technology, has the advantage, and finally discusses its application and the existence of two major problems and suggestions for improvement.

Dushan county, Guizhou province, is located in the southernmost tip of Guizhou province. It belongs to the temperate climate of the subtropical region and is one of the centers of the karst east Asia area. The total area of the county is 242220 hectares, of which 169142 hectares are rocky desertifi cation or endangered desertification state. At present, the problem of rocky desertification has seriously affected the ecological environment of the county, which is one of the important factors that restrict the local social living standard and economic development. Therefore, it is of great significance to promote the social and economic development of the county by investigating and analyzing the spatial differentiation rules, present situation and harm of rocky desertification in Dushan county.

Salicylaldehyde imine transition metal catalyst is a kind of olefin polymerization catalyst that is widely used in the coordination of salicylaldehyde imine ligand and pre-transition metal. Salicylaldehyde imine ligands have the characteristic of easily inserting different substituents via organic synthesis. Therefore, the regulation of the polymerization activity, polymerization product, and product distribution can be achieved by changing the steric hindrance effect, the electronic effect, and the number of metal active sites near the catalytic active center. The development status of the transition metal catalyst of salicylaldehyde imide was summarized in this paper. The influence of the ligand structure of the salicylaldehyde imide transition metal catalyst on the catalytic performance, which involved the high selectivity of ethylene trimerization, ethylene/α-olefin, polar monomer copolymerization, ethylene polymerization production, ultra-high molecular weight polyethylene, and many other areas of olefin polymerization, was elaborated, providing references for further study and industrial applications of this catalyst.

The effects of Zn2+ stress on seed germination, seedling growth and chlorophyll content were studied in order to better understand the effect of heavy metal Zn on the growth and development of green plants. The concentration gradient of Zn2+ was 20, 50,100,150,200,300,500,700mg / L, and deionized water was used as control. The results showed that under the Zn2+ stress condition, the germination index of the rhubarb seeds increased with the increase of Zn2+ concentration. Germination potential, germination rate and germination index were the highest when Zn2+concentration was 100mg / L, the conductivity was the lowest at zinc concentration of 100mg / L, the root length, stem length and chlorophyll content of Zn2+ gradually reduced. The results showed that the amount of Zn2+ could promote seed germination, but the root length, bud length and chlorophyll content of seedlings could be affected by different degrees. The zinc fertilizer should be used in the production.

Contemporary infrastructure research has its origins in the late 1980s as attempts were made to measure the economic impact of public expenditures with early mixed results. In the 1990s, infrastructure assumed greater importance as a policy solution to improve economic performance in low-income economies particularly by multilateral development and official development agencies. This interest led to greater research interest with the examination of infrastructure and economic development, foreign direct investment, the role of institutions and capital markets, procurement, regional economic effects and more recently, the productivity of public investment in specific regions and industries. 

This article identifies subjects that warrant further research in the future particularly the shortfall in current investment levels and how this will be met. This is a challenge for both low and high-income countries with fiscal and public debt constraints requiring governments to tap alternative sources of finance. Policy options available to government include wider use of bond markets and private participation in infrastructure provision and management. Other problems facing government include optimism bias and forecasting error that is a particular problem for projects in the transport sector. 

Many other research opportunities remain to be explored and this article is designed to provide an overview of several of the subjects that would benefit from further research at the present time. 

New telechelic polymers functionalized with terminal ethyl xanthate or vinyl groups were synthesized via cationic ring-opening polymerization (CROP). The polymerization of 2-ethyl-2-oxazoline (Etoxa) and 2-methoxycarbonylethyl-2-oxazoline (Esteroxa) was initiated by 1,4-trans-dibromobutene in acetonitrile at 78 ℃, with termination using either potassium ethyl xanthate or 4-vinylbenzyl-piperazine. Structural characterization by ¹H and ¹³C NMR and FTIR spectroscopy confirmed the telechelic architecture. ¹H NMR analysis revealed degrees of polymerization (DP) of 24–29 for ethyl xanthate-terminated polymers and 22–23 for vinyl-terminated polymers, consistent with theoretical values. The molar compositions of Etoxa and Esteroxa in all telechelic polymers matched the initial monomer feed ratios. End-group functionalization efficiency was quantified as follows: Ethyl xanthate-terminated polymers: 64%–82%, and vinyl-terminated polymers: 69% and 98% (for respective batches).