Segregating the scavenging processes from the lubrication methodology is a very effective way of improving two-stroke cycle engine durability. The application of stepped or twin diameter pistons is one such method that has repeatedly shown significantly greater durability over comparable crankcase scavenged engines together with an ability to operate on neat fuel without any added oil. This research study presents the initial results observed from a gasoline/indolene fuelled stepped piston engine ultimately intended for Hybrid Electric Vehicle and/or Range Extender Electric Vehicle application using hydrogen fuelling. Hydrogen fuelling offers the potential to significantly reduce emissions, with near zero emission operation possible, and overcoming the serious issues of range anxiety in modern transport solutions. The low environmental impact is discussed along with results from 1-d Computational Fluid Dynamic modelling. The engine type is a low-cost solution countering the financial challenges of powertrain duplication evident with Hybrid Electric and Range Extender Electric Vehicles.

In older adults with disabilities, muscle weakness reduces mobility and causes postural issues. Electrical muscle stimulation (EMS) training is effective for increasing strength by inducing involuntary skeletal muscle contractions. Thus, this study aimed to examine changes in lumbar movement, muscle activity during walking, and maximum muscle strength of lower-limb joints based on an 8-week EMS exercise program for older adults with physical disabilities. Sixteen older adults (aged 56–78 years) with physical disabilities were selected and randomly assigned to either the exercise group (EG, n = 8) or the control group (CG, n = 8). EG participants were instructed to wear EMS suits and participate in an elastic band and bare-body exercise program, whereas CG participants performed the exercise program without the EMS suits. Lumbar range of motion (ROM), body circumference, partial volume, maximum muscle strength, and muscle activity were measured. Statistical analysis was performed using SPSS 28.0 for Windows, with the critical value of α = 0.05. Compared to CG participants, EG participants had a superior ROM, body volume, partial volume, maximum muscle strength (knee joints), and muscle activity while walking. These positive outcomes highlight the efficacy of combining EMS with an exercise program for strength and rehabilitation training in older adults with physical disabilities.

In order to understand the finishing effect of Waterborne Acrylic Paint under different painting methods and amount, bamboo-laminated lumber for furniture was coated with waterborne acrylic paint, then the effects of different painting methods and amount on the drying rate, smoothness, hardness, adhesion and wear resistance of the paint film were investigated. Further, the mechanism of film formation was described by thermal property analysis using thermogravimetry and differential scanning calorimeter. The results show that different painting methods have little effect on film properties, the drying time of primer and topcoat are not affected by them, which is 8/8.5 min for primer surface/solid and 6.5/7 min for topcoats. The film surface hardness and adhesion can reach B and 0 grade, the best wear resistance of the film is 51.24 mg·100 r⁻¹ when using one-layer primer one-layer topcoat. Different coating amount has great influence on film properties, the drying speed of the film increases with the increase of the painting amount. The film properties reach the best when the painting amount is 80 g/m², while too little painting amount leads to the decrease of hardness, and too much leads to the wear resistance weaken. Thermal analysis of the primer and topcoat show that water decomposition occurs at 100 ℃ and thermal decomposition of organic components occur at 350 ℃. Topcoats have better thermal stability than primers higher than that of topcoat, the topcoat displayed better thermal stability than the primer.

This paper concerns a miniature gasifier fed with a constant ambient-pressure flow of air to study the pyrolysis and subsequent combustion stage of a single wood pellet at T = 800 ℃. The alkali release and the concentration of simple gases were recorded simultaneously using an improved alkali surface ionisation detector and a mass spectrometer in time steps of 1 s and 1.2 s, respectively. It showed alkali release during both stages. During combustion, the MS data showed almost complete oxidation of the charred pellet to CO₂. The derived alkali release, “O₂ consumed”, and “CO₂ produced” conversion rates all indicated very similar temporal growth and coalescence features with respect to the varying char pore surface area underlying the original random pore model of Bhatia and Perlmutter. But, also large, rapid signal accelerations near the end and marked peak-tails with O₂ and CO₂ after that, but not with the alkali release data. The latter features appear indicative of alkali–deprived char attributable to the preceding pyrolysis with flowing air. Except for the peak-tails, all other features were reproduced well with the modified model equations of Struis et al. and the parameter values resembled closely those reported for fir charcoal gasified with CO₂ at T = 800 ℃.

In the rapidly evolving landscape of China’s pharmaceutical industry, this study investigates how pharmaceutical enterprises can achieve profitable sales innovation amid the process of digital transformation. Grounded in the Affordance theory, it posits that the positive impact of digital transformation on sales innovation is driven by the affordance afforded by digital technology and ubiquity. The research focuses on A-share pharmaceutical companies in China, utilizing data from 2012 to 2022 and employing multiple regression analysis to examine the influence of digital transformation on corporate sales innovation. The results demonstrate a significant positive effect of digital transformation on sales innovation. The study further categorizes digital transformation into technological affordance and ubiquity affordance, separately validating their roles in promoting sales innovation. Moreover, by considering synergistic effects, the research unveils the intricate relationship between digital transformation and corporate innovation performance. The findings provide a fresh perspective on understanding how digital technology propels sales innovation and offer concrete guidance for the digital transformation practices in the pharmaceutical industry.