In order to understand the finishing effect of Waterborne Acrylic Paint under different painting methods and amount, bamboo-laminated lumber for furniture was coated with waterborne acrylic paint, then the effects of different painting methods and amount on the drying rate, smoothness, hardness, adhesion and wear resistance of the paint film were investigated. Further, the mechanism of film formation was described by thermal property analysis using thermogravimetry and differential scanning calorimeter. The results show that different painting methods have little effect on film properties, the drying time of primer and topcoat are not affected by them, which is 8/8.5 min for primer surface/solid and 6.5/7 min for topcoats. The film surface hardness and adhesion can reach B and 0 grade, the best wear resistance of the film is 51.24 mg·100 r−1 when using one-layer primer one-layer topcoat. Different coating amount has great influence on film properties, the drying speed of the film increases with the increase of the painting amount. The film properties reach the best when the painting amount is 80 g/m2, while too little painting amount leads to the decrease of hardness, and too much leads to the wear resistance weaken. Thermal analysis of the primer and topcoat show that water decomposition occurs at 100 ℃ and thermal decomposition of organic components occur at 350 ℃. Topcoats have better thermal stability than primers higher than that of topcoat, the topcoat displayed better thermal stability than the primer.
A novel composite material based on polymers (polyvinyl alcohol, polyvinyl butyral) and liquid crystal (4-n-pentyl-4’-cyanobiphenyl) has been developed and studied. Configuration transformations of point defects in nematic droplets under the influence of an electric field, caused by localized changes in the concentration of NLC within the polymer matrix, have been discovered and analyzed. The boundary conditions necessary for achieving a nematic structure with homogeneous alignment of the director both within the droplet and at its surface have been established, optimizing the anisotropy of light transmission in polymer-dispersed liquid crystal (PDLC) films. Additionally, polarization effects inside nematic droplets under the application of an electric field have been identified.
The interest in smart grids and new technologies is growing around the world. Countries are investing in the development of new technologies that will help achieve environmental goals, energy supply efficiency, improve energy efficiency and increase consumer involvement in the energy generation. One of such technology is a blockchain. It is believed that the blockchain, combined with a smart grid, provides an opportunity to integrate the activities of all stakeholders, including: generators, distributors and consumers of electricity. The aim of the article is to identify the key research areas discussed by the researchers of both the smart grid and the blockchain issues. An analysis of the Scopus database from 2015 to 2023 was conducted. Using a created bibliometric query, a systematic literature review was conducted. 476 scientific publications relating to the issues addressed were identified. Using the VOSviewer software, a bibliometric analysis was performed using the author’s keywords. The bibliometric maps obtained allowed for the identification of key research areas. The article also presents potential future directions of scientific considerations, which should be focused on the issue of green smart grid and green blockchain. The results presented in the article can inspire researchers looking for research gaps or describing the current state of knowledge in the field of the smart grid and the blockchain issues.
This research intends to find out the compliance acts based on the manufacturing industry of Bangladesh and lead to the development of the integrated theory of compliance model. There are several compliance regulations, that are separately dealt with in any manufacturing organization. These compliance regulations are handled at various ends of the organization making the process quite scattered, time-consuming, and tedious. To fix this problem, the integration of organizational compliance regulations is brought under one platform. Researchers have applied the qualitative approach with multiple case studies methodology scrutinizing the in-depth interviews and transcripts. Furthermore, the NVIVO tool has been used to analyze, where the necessary themes of the Organizational Compliance Regulations are found. Therefore, we have proposed a conceptual framework to inaugurate a standalone combined framework, which is an innovative and novel measure.
The COVID-19 pandemic had an adverse impact on the mental health of frontline workers including firefighters. To better understand this occurrence, this cross-sectional study evaluated the prevalence of depression, anxiety, and stress among 105 operational team and elite team firefighters in Kota Bharu, Kelantan State, Malaysia before and after the pandemic. The Depression, Anxiety and Stress Scale-21 (DASS-21), a validated self-reporting survey tool, was used to assess symptoms of depression, anxiety, and stress among the survey respondents. Findings revealed that firefighters had an increased level of anxiety and depression during the post-pandemic period compared to the pre-pandemic period. However, there was a decrease in the stress levels (20%) reported by study participants. Respondents belonging to the operational team had a higher reported level of depression, anxiety, and stress than those from the elite team. This may be attributed the operational team being more exposed to the risk of COVID-19 infection on account of their routine and more voluminous workload. The findings of this study suggest that firefighters, in general, are at an increased risk of mental health problems as a result of the COVID-19 pandemic. Knowing this, it is important to consider these findings when addressing the prevention and management of mental health among firefighters. This includes providing additional support and devoting more resources to those who are most at risk for experiencing symptoms of mental health such as firefighters performing functions aligned with that of an operational team.
The UN agenda of Sustainable Development Goals (SDGs) 2015–2030 is a holistic approach. Universities play an important role in dissemination of quality knowledge, developing the skills and attitudes of a large number of youth across the world. Though the emphasis on Education for Sustainable Development (ESD) started as early as 1992, yet Universities adopted the concept of Green Campus integrating the environmental, social and economic aspects of sustainability quite recently. In developing countries including Pakistan, the Green Campus Initiatives (GCI) have not been implemented in the majority of the Universities. Northern Pakistan comprising Azad Jammu & Kashmir (AJ&K) and Gilgit Baltistan (GB) faces multiple challenges including Climate Impacts at the top. The fragile ecosystem of the region requires more sustainable initiatives at the University and community levels. In this research, the readiness of the seven universities located in Northern Pakistan have been assessed for GCI on the basis scanning of the websites and questionnaire survey of the relevant stakeholders. The results have shown that there is little commitment of resources for sustainability from senior management, lack of awareness in faculty & staff and less research focus on the related themes of green campus. The co-curricular activities in universities are not linked with sustainability and there are no incentives for faculty, staff and students to this end. It has been recommended that Green Campus Framework may be developed for Pakistani Mountain Universities, with commitment from leaders of the universities and allocation of sufficient resources for development of sustainable campuses. The Higher Education Commission of Pakistan (HEC) needs to allocate special funds for promoting GCI across universities in Pakistan.
Copyright © by EnPress Publisher. All rights reserved.