The technology of vermicomposting containing their leachates, teas and other extracts such as vermiwash as a result of earthworm action is widely applied for safe management of agricultural, industrial, domestic and hospital wastes. Remediation of polluted soils, improving crop productivity and inducing the resistance against biotic and abiotic stresses are other advantages of vermicompost derived liquids when used in agriculture. Contrary to the fact that chemical fertilizers are still widely used in agriculture, societies gradually become aware of the negative effects of these fertilizers on their health. Therefore, vermicompost derived liquids contain high amount of valuable plant nutrients which has the potential to be used as liquid fertilizer. This paper reviews the potential of vermicompost derived liquids as as an efficient combination of nutrient source of vermicompost derived liquids contributing to plant growth and acting as a deterrent to biotic and abiotic stresses.

The present study demonstrates the fabrication of heterogeneous ternary composite photocatalysts consisting of TiO₂, kaolinite, and cement (TKCe),which is essential to overcome the practical barriers that are inherent to currently available photocatalysts. TKCe is prepared via a cost-effective method, which involves mechanical compression and thermal activation as major fabrication steps. The clay-cement ratio primarily determines TKCe mechanical strength and photocatalytic efficiency, where TKCe with the optimum clay-cement ratio, which is 1:1, results in a uniform matrix with fewer surface defects. The composites that have a clay-cement ratio below or above the optimum ratio account for comparatively low mechanical strength and photocatalytic activity due to inhomogeneous surfaces with more defects, including particle agglomeration and cracks. The TKCe mechanical strength comes mainly from clay-TiO₂ interactions and TiO₂-cement interactions. TiO₂-cement interactions result in CaTiO₃ formation, which significantly increases matrix interactions; however, the maximum composite performance is observed at the optimum titanate level; anything above or below this level deteriorates composite performance. Over 90% degradation rates are characteristic of all TKCe, which follow pseudo-first-order kinetics in methylene blue decontamination. The highest rate constant is observed with TKCe 1-1, which is 1.57 h⁻¹ and is the highest among all the binary composite photocatalysts that were fabricated previously. The TKCe 1-1 accounts for the highest mechanical strength, which is 6.97 MPa, while the lowest is observed with TKCe 3-1, indicating that the clay-cement ratio has a direct relation to composite strength. TKCe is a potential photocatalyst that can be obtained in variable sizes and shapes, complying with real industrial wastewater treatment requirements.

The objective of this research was to evaluate the unit rates of MSW generation in Cumba in the years 2016 and 2022. The calculations were based on the weights of the MSW disposed in the dump located 5 km from the city of Cumba since 2012. The GPC, physical composition, density, humidity were determined in the years 2016 and 2022, studied according to the methodology and group classification of Peruvian regulations. The results show that 5.45 Tn/day⁻¹ are generated in 2016, 4.37 Tn/day⁻¹ in 2022; according to its physical composition, 82% RO, 14% MICVC and 4% MISVC in 2016; 77% RO, 16% MICVC, 7% MISVC in 2022; density 137.90 kg/m⁻³ in 2016 and 172.69 kg/m⁻³ in 2022; humidity 67.67% in 2016 and 63.43% in 2022. It was also found that in 100.00% there is no solid waste treatment; Everything generated in homes, businesses and streets is evacuated to the final disposal site, which is a dump. In 2022, Cumba acquired 10 hectares to have adequate sanitary infrastructure and begin the closure and recovery of its current dump. This study will contribute to providing accurate data on MSW generation that allows the local government to promote the optimization of collection routes and schedules, resulting in cost savings and reduction of carbon emissions in the Amazon Region. Therefore, it is necessary to raise awareness at all levels of society through various means of communication and education, so that the risks of spreading health risks can be minimized by improving MSW management.

The study is devoted to the problem of processing the organic waste that is generated as a result of paper, textiles and other industries production as well as food waste. The growth of economic activity in Kazakhstan has resulted in a significant challenge with regard to industrial waste management. The accumulation of waste on the territory of the country has reached 31.72 billion tonnes, comprising approximately 2.5 billion tonnes of hazardous waste, 50 million tonnes of phosphorus-containing waste, over 2.5 million tonnes of lead-zinc waste and more than 120 million tonnes of solid domestic waste. The study object was the Shymkent-Kokys polygons. According to the research carried out, it was determined that the titer of microorganisms of the studied groups is 1–10 CFU/g in the soils selected around the garbage in the area of the Shymkent landfill. The titer of microorganisms in the soil horizons was high at a depth of 20–30 cm and the titer were 10⁹ cells/mL. The structure of the soil microbiome obtained around the Shymkent Waste Landfill consists of actinomycetes, micromycetes, heterotrophic bacteria, nitrifying, nitrogen-fixing bacteria, enterobacteria, as well as algae and protozoa. It was found that strains KPA1, KPA2 Pseudomonas sp. strains KPA3, KPA4, KPA5 Bacillus sp. isolated from the soils of the Shymkent-Kokys landfill are able to recycle domestic waste with a high content of cellulose and organic substances up to 95%–97%. The findings can be used to develop more effective organic cellulosic waste management strategies and improve the environmental sustainability of various industries.