Ce⁴⁺-doped nanometer ZnO powder was synthesized by so-l gel method. The microstructures and properties of the samples were characterized through XRD, UV-Vis and FTIR. The results indicated that the Ce⁴⁺ was successfully incorporated into ZnO, and the diameter of the nanometer was about 10.7nm. It induced the redshifting in the UV-Vis spectra. The photocatalytic activity of the samples was investigated using methylene blue (MB) as the model reaction under irradiation with ultraviolet light. The results showed that the doping of Ce⁴⁺ could increase the photocatalytic activities of ZnO nanopowders and that the best molar ratio of Ce⁴⁺ was n(Ce)/n(Zn) = 0.05, that the surfactant was sodium dodecyl sulfate, and that the nanometer ZnO was calcinated at 550 ℃ for 3 hours. Meanwhile, it inspected the effect of photocatalytic efficiency through the pH of MB, the amount of catalyst, and illumination time. The experimental results revealed that the initial mass concentration of MB was 10 mg/L, that the pH value was 7-8, that the dosage of Ce⁴⁺/ZnO photo-catalyst was 5 g/L, that the UV-irradiation time was 2 h, and that the removal rate of MB reached above 85%. Under the optimized conditions, the degradation rate of real dye wastewater was up to 87.67% and the removal efficiency of COD was 63.5%.

Zero-valent iron is a moderately reducing reagent that is both non-toxic and affordable. In the present work, iron nanoparticles were synthesized using bitter guard leaf extract (Momordica charantia L.) (BGL-Fe NP). Using leaf samples from bitter protectant extract, iron nanoparticles were synthesized with secondary metabolites such as flavonoids and polyphenols acting as capping and reducing agents. Polyphenols reduce Fe²⁺/Fe³⁺ to nanovalent iron or iron nanoparticles. Iron nanoparticles were synthesized by reducing iron chloride as a precursor with bitter protective leaf extract in an alkaline environment. The obtained BGL-Fe NPs were calcined for 4 h at various temperatures of 400 °C, 500 °C, and 600 °C. The obtained samples were coded as BGL-Fe NPs-4, BGL-Fe NPs-5, and BGL-Fe NPs-6, respectively. The synthesized BGL-Fe NPs were systematically characterized by XRD, SEM, FTIR, UV-Vis and TG-DTA analysis. The obtained BGL-Fe NPs were then used as an adsorbent to remove the aqueous solution of basic methylene blue (MB) dye. MB concentration was monitored using UV-Vis spectroscopy.

Different color-promoting treatments were tested on table grape cv. “Flame Seedlees” to evaluate changes on flavonoids such as anthocyanins and the residual ethylene produced. Treatments were spray-applied at the onset of veraison. The control was Ethrel at 250 ppm (ETH), Salicylic Acid at 100 ppm (AS), Melatonin at 25 ppm (MEL) and 1:1 mixtures of ETH+AS, ETH+MEL and AS+MEL. The trials were conducted in triplicate after harvest, measuring Total Soluble Solids (% TSS), total acidity (% tartaric acid), pH, residual ethylene (ppm) and anthocyanin content (mg∙cm^-2). It was found that treatments ETH, AS, MEL and ETH+AS reached 16% TSS, standing out with lower values ETH +MEL (14.27%) and AS+MEL (15.17%) (p ≤ 0.05). ETH reached 0.83 ppm of residual ethylene, while a sum effect was appreciated in ETH+AS (0.5 ppm) and ETH+MEL (0.35 ppm), but not beneficial as it did not reflect quality characteristics. Only differences (p ≤ 0.05) in anthocyanin content were recorded between ETH (0.019 mg∙cm^-2) and AS+MEL (0.003 mg∙cm^-2). The subjective color of the grape bunches in the field made it possible to relate it to the objective results of the analyses performed. This research provides commercially important information on the substitution of Ethrel by natural compounds such as AS and MEL, as they show similar effects on the quality of “Flame Seedless” table grapes. In addition, these compounds do not have an ethylene residual greater than 0.2 mg/kg.

Fe3+-doped nano-TiO2 powders were prepared by sol-gel method. The photocatalytic activity of Fe3+-doped TiO2 nanoparticles was studied by using UV lamp as light source and methylene blue as degradation target. The photocatalytic activity of Fe3+-doped TiO2 was studied by degradation of 4L methylene blue solution with initial concentration of 10mg · L - 1. The results show that the photocatalytic activity of TiO2 can be improved by the addition of Fe3+. When the molar ratio of Fe3+ is 0.5-1%, the calcination temperature is 500 ℃. The photocatalytic degradation of methylene blue is the best.