Tomato powdery mildew, fruit rot, and twig blight are all managed with Deltamethrin. Its residues could still be present in the crops, posing a health risk. The pesticide residue analysis, dissipation rate, and safety assessments were thus examined in green tomatoes. The analytical method for residue analysis was validated according to international standards. Tomato fruits and soil were used to study the dissipation of Deltamethrin 100 EC (11% w/w) at 12.5 g a.i ha⁻¹ for the recommended dose (RD) and 25.0 g a.i ha⁻¹ for the double of the recommended dose (DD). Ethyl acetate was used to extract residues from tomato fruit, and PSA and magnesium sulphate were used for cleanup.The fruits had recoveries ranging from 83% to 93% and the soil sample from 81.67% to 89.6%, with the limit of detection (LOQ) estimated at 0.01 mg kg⁻¹. The matrix effect (ME) was calculated to be less than 20% for the tomato fruits and the soil.Half-lives for RD and DD were 1.95 and 1.84 days, respectively. All sampling days for both doses had dietary exposures of residues below the maximum permissible intake (MPI) of 0.16 mg person⁻¹ day⁻¹. The most effective method of decontaminating tomato residue containing Deltamethrin is blanching.

Bangladesh’s coastal regions are rich in saline water resources. The majority of these resources are still not being used to their full potential. In the southern Bangladeshi region of Patuakhali, research was conducted to investigate the effects of mulching and drip irrigation on tomato yield, quality, and blossom-end rot (BER) at different soil salinity thresholds. There were four distinct treatments applied: T₁= drip irrigation with polythene mulch, T₂ = drip irrigation with straw mulch, T₃ = drip irrigation without mulch, and T₄ = standard procedure. While soil salinity was much greater in treatment T₃ (1.19–8.42 dS/m) fallowed by T₄ (1.23–8.63 dS/m), T1 treatments had the lowest level of salinity and the highest moisture retention during every development stage of the crops, ranging from 1.28–4.29 dS/m. Treatment T₃ exhibited the highest soil salinity levels (ranging from 1.19 to 8.42 dS/m), followed by T₄ with a range of 1.23 to 8.63 dS/m. In contrast, T₁ treatments consistently maintained the lowest salinity levels (ranging from 1.28 to 4.29 dS/m) and the highest moisture retention throughout all stages of crop development. In terms of yield, drip irrigation with no mulch treatment (T₃) provided the lowest output (13.37 t/ha), whereas polyethylene mulching treatment (T₁) produced the maximum yield (46.04 t/ha). According to the study, conserving moisture in tomato fields and reducing soil salinity may both be achieved with drip irrigation combined with polythene mulch. The research suggests that employing drip irrigation in conjunction with polythene mulch could effectively preserve moisture in tomato fields and concurrently decrease soil salinity.

Soil salinity is a major abiotic stress that drastically hinders plant growth and development, resulting in lower crop yields and productivity. As one of the most consumed vegetables worldwide, tomato (Solanum lycropersicum L.) plays a key role in the human diet. The current study aimed to explore the differential tolerance level of two tomato varieties (Rio Grande and Agata) to salt stress. To this end, various growth, physiological and biochemical attributes were assessed after two weeks of 100 mM NaCl treatment. Obtained findings indicated that, although the effects of salt stress included noticeable reductions in shoots’ and roots’ dry weights and relative growth rate as well as total leaf area, for the both cultivars, Rio Grande performed better compared to Agata variety. Furthermore, despite the exposure to salt stress, Rio Grande was able to maintain an adequate tissue hydration and a high leaf mass per area (LMA) through the accumulation of proline. However, relative water content, LMA and proline content were noticeably decreased for Agata cultivar. Likewise, total leaf chlorophyll, soluble proteins and total carbohydrates were significantly decreased; whereas, malondialdehyde was significantly accumulated in response to salt stress for the both cultivars. Moreover, such negative effects were remarkably more pronounced for Agata relative to Rio Grande cultivar. Overall, the current study provided evidence that, at the early growth stage, Rio Grande is more tolerant to salt stress than Agata variety. Therefore, Rio Grande variety may constitute a good candidate for inclusion in tomato breeding programs for salt-tolerance and is highly recommended for tomato growers, particularly in salt-affected fields.

Tomato (Solanum lycopersicon L.) is a highly valued crop in the world, particularly in Nigeria with high nutritional and economic benefits. However, its production in Iwollo, Southeast Nigeria, is constrained by unfavorable weather conditions. To address this, a study was conducted at the Teaching and Research Farm, Department of Horticultural Technology, Enugu State Polytechnic, Iwollo, Southeast Nigeria to evaluate and select the best cultivar for high tunnel production using the Rank Summation Index. Completely Randomized Design with three replications was used, and six high-yielding cultivars, namely Roma VF, BHN-1021, Supremo, Pomodro, Money maker, and Iwollo local, were evaluated. Data were collected on key agronomic characters and analyzed with Analysis of Variance (ANOVA) at a 0.05 level of probability. There were significant differences in the number of leaves per plant, plant height, number of branches per plant, days to fruit maturity, fresh fruit weight, number of harvested fresh fruits per plant, and fresh fruit yield per plant among the cultivars. These characters that showed significant differences were ranked and summed up to obtain the Rank Summation Index (RSI) score. The results revealed that the Supremo cultivar had the lowest and best score (18). This suggests Supremo as the best cultivar for high tunnel tomato production in the study area, based on its superior performance across key agronomic traits.