The study examines the impact of various theories on the reflection and transmission phenomena caused by obliquely incident longitudinal and transverse waves at the interface between a continuously elastic solid half-space and a thermoelastic half-space, using multiple thermoelastic models. Numerical calculations reveal that the thermoelastic medium supports one transmitted transverse wave and two transmitted longitudinal waves. The modulus of amplitude proportions is analyzed as a function of the angle of incidence, showing distinct variations across the studied models. Energy ratios, derived from wave amplitudes under consistent surface boundary conditions for copper, are computed and compared across angles of incidence. The results demonstrate that the total energy ratio consistently sums to one, validating energy conservation principles. Graphical comparisons of amplitude proportions and energy ratios for SV and P waves across different models illustrate significant differences in wave behavior, emphasizing the influence of thermoelastic properties on wave transmission and reflection.

The current study provides a comprehensive analysis of MHD hybrid nanofluids and stagnation point flow toward a porous stretched cylinder in the presence of thermal radiation. Here, alumina (Al₂O₃) and copper (Cu) are considered the hybrid nanoparticles, while water (H₂O) is the base fluid. To begin, the required similarity transformations are applied to transform the nonlinear coupled PDEs into nonlinear coupled ODEs. The obtained highly nonlinear sets of ODEs are then solved analytically by using the HAM procedure. The calculations of the thermal radiation term in the energy equation are done based on the Roseland approximation. The result of various embedded variables on temperature and velocity profiles is drawn and explained briefly. Aside from that, the numerical solution of well-known physical quantities, like skin friction and the Nusselt number, is computed by means of tables for the modification of the relevant parameter. The analysis shows that the magnetic field has opposite behavior on θ(η) and f'(η) profiles. It is seen that more magnetic factors M decline f'(η) and upsurge θ(η). Moreover, the behavior of skin friction and the Nusselt number are the same for the magnetic parameter M. Meanwhile, a higher Reynolds number R_e declines temperature profile and skin friction while upsurging the local Nusselt number. There are many applications of this study that are not limited to engineering and manufacturing, such as polymer industry, crystal growth, tumor therapy, plasma, fusing metal in electric heaters, nuclear reactors, asthma treatment, gastric medication, cooling of atomic systems, electrolytic biomedicine, helical coil heat exchangers, axial fan design, polymer industry, plane counter jets, and solar collectors.

A panel data analysis of nonlinear government expenditure and income inequality dynamics in a macroprudential policy regime was conducted on a panel of 15 emerging countries from 1985–2019, where there had been a non-prudential regime from 1985–1999 and a prudential regime from 2000–2019. The paper explored the validity of the nonlinearity between government expenditure and income inequality in the macroprudential policy regime as well as the threshold level at which excessive spending reduces income inequality using the Bayesian spatial lag panel smooth transition regression (BSPSTR) and fix effect models. The BSPSTR model was adopted due to its ability to address the problems of heterogeneity, endogeneity, and cross-section correlation in a nonlinear framework. Moreover, as the transition variable often varies across time and space, the effect of the independent variables can also be time- and space-varying. The results reveal evidence of a nonlinear effect between government spending and income inequality, where the minimum level of government spending is found to be 29.89 percent of GDP, above which expenditure reduces inequality in emerging countries. The findings confirmed an inverted U-shaped relationship. The focal policy recommendation is that fiscal policy decisions that will reinforce the need for more emphasis on education and public expenditure on education and health, as important tools for improving income inequality, are crucial for these economies. Caution is needed when introducing macroprudential policies, especially at a low level of government expenditure.

Introduction: The selection of genotypes with determinate growth habit in tomato should contemplate adequate selection criteria to increase the efficiency of the breeding program. Objective: The objective of this work was to estimate selection criteria for “chonto” type tomato lines with determined growth habit. Materials and methods: This work was carried out at the Universidad Nacional de Colombia (Palmira Campus), in 2016, with seven lines with determinate growth habit and a control with indeterminate growth. Heritability in a broad sense (h² g), coefficient of environmental variation, coefficient of genetic variation, selection efficiency and genetic gain were determined in parameters of morphological, phonological, fruit quality, fruit shape and production, using the RELM/BLUP procedure of the SELEGEN software. Results: There were three ranges of h² g, the first with values of h² g greater than 0.76, the second between 0.53 and 0.38, and the third with a value less than 0.38. The highest values of h² g were for final plant height with 0.92, plant height at harvest with 0.88, yield per plant with 0.83, days to flowering with 0.83, number of fruits per plant with 0.82, and days to harvest with 0.82. For genetic gain it was found that the control had the highest values for final plant height, plant height at harvest, internode length, days to harvest, harvest duration, soluble solids content, number of fruits per plant, fruit weight and yield per plant; however, in some parameters such as height and phenology for selection by determined growth habit, the lowest values were better. Conclusion: There was evidence of genetic parameters that could be considered as selection criteria for “chonto” type tomato lines with determinate growth habit.

One of the main concerns in computer science today is integrating the Internet of Things (IoT) into manufacturing processes. This trend could influence a country’s strategy and policy development regarding technological infrastructure. However, despite extensive research on the implementation of IoT in manufacturing, no study has yet focused on the growing research interest in this topic. Based on 2487 papers indexed in the Scopus database between 2013 and 2023, this bibliometric review examines current trends and patterns in IoT research in manufacturing. The literature was selected and screened using the Preferred Reporting Items for Systematic Reviews and Meta-Analyses (PRISMA) 2020 guidelines. Data visualization was created using VOSviewer. The results show a notable increase in research papers centered around IoT in manufacturing. The findings reveal patterns and trends in IoT research publications in the manufacturing sector, author collaboration networks, country collaboration networks, and both established and newly trending topics surrounding IoT in the manufacturing industry.

The possibility of preoperative prediction of pathologic complete response in rectal cancer has been studied in order to identify patients who would respond to neoadjuvant therapy and to individualize therapeutic strategies. Endoscopic ultrasound of the rectum is an accurate method for the evaluation of local tumor and lymph node invasion. Objective: To evaluate the potential of endoscopic ultrasound as a predictor of complete pathological response to neoadjuvant treatment in patients with locally advanced rectal cancer. Material and methods: Retrospective study of patients with rectal cancer from January 2014 to December 2016. Results: We obtained a statistical association between T stage by endoscopic ultrasound and complete pathological response (p = 0.015). It is not so for N, sphincter involvement, circumferential involvement and maximum tumor thickness (p = 0.723, p = 0.510, p = 0.233 and p = 0.114, respectively). When multivariate logistic regression analysis was applied to assess the degree of influence of the predictor variables on pathologic response, none of these variables was associated with complete pathologic response. Conclusion: Prediction of pathologic complete response in rectal cancer has been considered as the crucial point upon which treatments for rectal cancer could be individualized. So far, no imaging method has been able to demonstrate efficacy in predicting complete pathologic response, and in turn there is no direct association between any endosonographic finding that can accurately predict it.