Every production day in Nigeria, and in other oil producing countries, millions of barrels of produced water is generated. Being very toxic, remediation of the produced water before discharge into environment or re-use is very essential. An eco-friendly and cost effective approach is hereby reported for remediative pre-treatment of produced water (PW) obtained from Nigerian oilfield. In this approach, Telfairia occidentalis stem extract-silver nanoparticles (TOSE-AgNPs) were synthesized, characterized and applied as bio-based adsorbent for treating the PW in situ. The nanoparticles were of average size 42.8 nm ± 5.3 nm, spherical to round shaped and mainly composed of nitrogen and oxygen as major atoms on the surface. Owing to the effect of addition of TOSE-AgNPs, the initially high levels (mg/L) of Total Dissolved Solids (TDS), Biological Oxygen Demand (BOD) and TSS of 607, 3.78 and 48.4 in the PW were reduced to 381, 1.22 and 19.6, respectively, whereas DO and COD improved from 161 and 48.4 to 276 and 19.6 respectively, most of which fell within WHO and US-EPA safe limits. Particularly, the added TOSE-AgNPs efficiently removed Pb (II) ions from the PW at temperatures between 25 ℃ to 50 ℃. Removal of TOSE-AgNPs occurred through the adsorption mechanism and was dependent contact time, temperature and dose of TOSE-AgNPs added. Optimal remediation was achieved with 0.5 g/L TOSE-AgNPs at 30 ℃ after 5 h contact time. Adsorption of Pb (Ⅱ) ions on TOSE-AgNPs was spontaneous and physical in nature with remediation efficiency of over 82% of the Pb (Ⅱ) ions in solution. Instead of discarding the stem of Telfairia occidentalis, it can be extracted and prepared into a new material and applied in the oilfield as reported here for the first time.

Cancer is the 3rd leading cause of death globally, and the countries with low-to-middle income account for most cancer cases. The current diagnostic tools, including imaging, molecular detection, and immune histochemistry (IHC), have intrinsic limitations, such as poor accuracy. However, researchers have been working to improve anti-cancer treatment using different drug delivery systems (DDS) to target tumor cells more precisely. Current advances, however, are enough to meet the growing call for more efficient drug delivery systems, but the adverse effects of these systems are a major problem. Nanorobots are typically controlled devices made up of nanometric component assemblies that can interact with and even diffuse the cellular membrane due to their small size, offering a direct channel to the cellular level. The nanorobots improve treatment efficiency by performing advanced biomedical therapies using minimally invasive operations. Chemotherapy’s harsh side effects and untargeted drug distribution necessitate new cancer treatment trials. The nanorobots are currently designed to recognize 12 different types of cancer cells. Nanorobots are an emerging field of nanotechnology with nanoscale dimensions and are predictable to work at an atomic, molecular, and cellular level. Nanorobots to date are under the line of investigation, but some primary molecular models of these medically programmable machines have been tested. This review on nanorobots presents the various aspects allied, i.e., introduction, history, ideal characteristics, approaches in nanorobots, basis for the development, tool kit recognition and retrieval from the body, and application considering diagnosis and treatment.

The present study demonstrates the effect of direct solar drying (DSD) and hot air drying (HAD) on the quality attributes of Fuji apple slices. DSD samples took a longer time (150–180 min) to dry and simultaneously reached higher equilibrium moisture content at the end of rehydration than HAD samples. DSD samples have higher rehydration ability, dry matter holding capacity, and water absorption capacity than HAD samples. Among several empirical models, the Weibull model is the best fit with higher R² (0.9977), lower root mean square (0.0029), and chi-square error (0.0031) for describing the rehydration kinetics. Rehydrated HAD samples showed better color characteristics than DSD in terms of overall color change, chroma, and hue angle values. Whereas the hardness and chewiness of rehydrated DSD samples were better than HAD samples because of higher dry matter holding capacity in DSD. Apart from color retention, the DSD samples showed better rehydration capacity and a good texture upon rehydration than HAD slices.

In the last several decades, cardiovascular diseases (CVDs) have emerged as a major hazard to human life and health. Conventional formulations for the treatment of CVD are available, but they are far from ideal because of poor water solubility, limited biological activity, non-targeting, and drug resistance. With the advancement of nanotechnology, a novel drug delivery approach for the treatment of CVDs has emerged: nano-drug delivery systems (NDDSs). NDDSs have shown significant advantages in tackling the difficulties listed above. Cytotoxicity is a difficulty with the use of non-destructive DNA sequences. NDDS categories and targeted tactics were outlined, as well as current research advancements in the diagnosis and treatment of CVDs. It’s possible that gene therapy might be included into nano-carriers in the delivery of cardiovascular medications in the future. In addition, the evaluation addressed the drug’s safety.

Depression is a mental disorder caused by various causes with significant and persistent depressed mood as the main clinical feature, and is the most common mental illness worldwide and in our country. The number of patients with depression worldwide was as high as 350 million in 2017, and the number of patients with depression in our country was nearly 100 million in 2019. The greatest danger of depression is self-injurious and suicidal behaviour, and this behaviour carries a high medical burden. Medication is the most costly treatment for depression in China, and while it is an effective way to treat patients with depression, it has many side effects and poor patient compliance. Non-pharmacological treatments commonly used in clinical practice include physiotherapy and psychotherapy. Physiotherapy is commonly used in non-convulsive electroconvulsive therapy, but its clinical efficacy is uncertain and it can also cause adverse effects such as heart failure and arrhythmias, which are poorly tolerated by patients. Psychotherapy is also a common non-pharmacological therapy. Cognitive therapy is a common form of psychotherapy, but the cycle of cognitive therapy is too long, the cost to the patient is high, and the patient’s cognitive ability has certain requirements. Music therapy is a combination of art and science. It is a cross-discipline that combines body, movement, dance and psychology and is a method of psychotherapy that has biological, psychological and social functions to compensate for deficiencies. Music therapy sees a fundamental connection between mind and body and emphasises that what affects the body also affects the mind. When mind-body integration is lacking, individuals will suffer from a variety of psychological disorders. Therefore, the core principles of music therapy emphasise that holistic individual health is embodied in the integration of mind and body, that body movement is expressive and communicative, and that music therapy uses body movement as a method of assessing the individual and as a means of clinical intervention.

In order to improve the quality and efficiency of heat treatment in welds of power stations, this paper summarizes the current situation of 600 MW supercritical power plant welding site heat treatment and puts forward the improved methods and measures accordingly. The heat treatment of welding holes in the construction site Play a certain guiding role.