Lithospermum extract from Lithospermum is a kind of naphthoquinone, which has good anti-ultraviolet and anti-bacterial function. In this paper, the effects of different treatment temperature, time and ratio of liquid to liquid on the UV resistance of Lithospermum erythrorhizon extract were studied. The optimum extraction conditions were as follows: extraction temperature 60 ℃, extraction time 2 h, ratio of liquid to liquid of Lithospermum and ethanol 1:11. In this paper, the anti-UV finishing of cotton fabric was carried out, and the anti-ultraviolet and whiteness of the fabric were taken as the main indexes. The optimum process of the anti-UV finishing was as follows: the impregnation temperature was 70 ℃, the immersion time was 2h, 1:40. Compared with the uncoated cotton fabric, the fabric UPF value of the fabric was improved from 12.31 to 83.25, and the anti-ultraviolet performance was excellent, and it had certain bacteriostatic effect on Bacillus subtilis and Escherichia coli.

Fe3+-doped nano-TiO2 powders were prepared by sol-gel method. The photocatalytic activity of Fe3+-doped TiO2 nanoparticles was studied by using UV lamp as light source and methylene blue as degradation target. The photocatalytic activity of Fe3+-doped TiO2 was studied by degradation of 4L methylene blue solution with initial concentration of 10mg · L - 1. The results show that the photocatalytic activity of TiO2 can be improved by the addition of Fe3+. When the molar ratio of Fe3+ is 0.5-1%, the calcination temperature is 500 ℃. The photocatalytic degradation of methylene blue is the best.

The development status of flat panel solar water heater and the composition of water heater are described. The solar radiation in three typical weather conditions of sunny, cloudy and rainy days is studied. The hot water temperature, heat and heat collector efficiency are studied. The results show that the influence of the weather on the solar irradiance is large, and the irradiance has a great influence on the water temperature.

Objective: to determine the diagnostic performance of magnetic resonance hysterosalpingography (HSG-MRI), using laparoscopy as the reference method. Materials and methods: 22 patients were included. All underwent HSG-MRI with a 1.5 Tesla resonator and then laparoscopy with chromotubation. Two radiologists examined the MRIs, determining tubal patency by consensus. Descriptive and diagnostic performance analyses were performed. Results: HSG-MRI had a success rate of 91%. Study duration was 49 ± 15 minutes, volume injected 26 ± 16 cm³ and pain scale 30 ± 19 out of 100. Sensitivity and specificity of HSG-MRI were 100% for global and left Cotte test, and 25% and 93.3% for right Cotte test, respectively. There were 2 minor complications and no major complications. Discussion: our initial results demonstrated high sensitivity and specificity. Although other studies analyzed the ability of HSG-MRI to assess tubal patency with good results, the use of a flawed reference standard left room for reasonable doubt, preventing a recommendation based on solid evidence. However, when comparing our results with those published, we observed a high degree of concordance insofar as the positive effusion is correctly diagnosed with a specificity of 100% or with a percentage close to this figure.