The optimized methodology and results of the new characterization in terms of dose and image quality of the X-ray system used in the main pediatric hemodynamics service in Chile are presented. In addition, scattered dose rate values at the operator’s eye level are reported for all acquisition modes available in different thicknesses of absorbent media and angiography. The characterization was performed according to the European DIMOND and SENTINEL protocols adapted to pediatric procedures. The air kerma at the entrance surface (ESAK) was measured and the image quality parameters signal-to-noise ratio (SNR) and a figure of merit (FOM) were calculated. The scattered dose rate was measured in personal dose equivalent units. The ESAK for fluoroscopic modes ranged from 0.2 to 35.6 μGy/image when passing from 4 to 20 cm of polymethyl methacrylate (PMMA). For the cine mode, these values ranged from 2.8 to 160.1 μGy/image. The values of the image quality parameters showed a correct system configuration, although abnormal values were observed in the medium fluoroscopic mode. As for the scattered dose rate at the level of the cardiologist’s eyes, the highest value is PMMA with a thickness of 20 cm, where the cine mode reached 9.41 mSv·h-1. The differences found from previous evaluations can be explained by the deterioration of the system and the change of one of the X-ray tubes.

The smallest administrative unit of the sixth national census-township (town) is selected as the basic unit, the population spatial distribution characteristics at the township (town) level in karst mountainous areas of northwest Guangxi are analyzed by using Lorenz curve and spatial correlation analysis method, and the influence intensity of natural factors on regional population spatial distribution is detected by using geographic detector method. The results show that: 1. the spatial distribution of population at the township (town) level has the characteristics of imbalance, showing generally significant positive correlation and certain aggregation; 2. There are significant differences in the impact of the spatial distribution of various natural factors on the population distribution. For the towns without karst distribution in the northwest and central south of the study area, the population density increases with the increase of factors conducive to human residence, but the average population density is only 79 people/km². In the towns with karst distribution in the East and south, the spatial distribution of population density and natural factors is not a simple increase or decrease relationship, but fluctuates with the change of karst distribution area. 3. The factor detection results of the geographic detector show that the altitude has the greatest impact on the spatial distribution of population. The interactive detection results show that the impact intensity of any two natural factors after superposition and interaction presents nonlinear enhancement and two factor enhancement. It can be seen that the karst mountain area in northwest Guangxi is similar to other areas. Altitude is one of the main factors affecting the spatial distribution of population, but the river network density and unique geological landform of karst mountain area have a strong catalytic effect on the spatial distribution of population. The superposition and interaction with other factors can further strengthen the impact on population distribution.

Based on the population change data of 2005–2009, 2010–2014, 2015–2019 and 2005–2019, the shrinking cities in Northeast China are determined to analyze their spatial distribution pattern. And the influencing factors and effects of shrinking cities in Northeast China are explored by using multiple linear regression method and random forest regression method. The results show that: 1) In space, the shrinking cities in Northeast China are mainly distributed in the “land edge” areas represented by Changbai Mountain, Sanjiang Plain, Xiaoxing’an Mountain and Daxing’an Mountain. In terms of time, the contraction center shows an obvious trend of moving northward, while the opposite expansion center shows a trend of moving southward, and the shrinking cities gather further; 2) in the study of influencing factors, the results of multiple linear regression and random forest regression show that socio-economic factors play a major role in the formation of shrinking cities; 3) the precision of random forest regression is higher than that of multiple linear regression. The results show that per capita GDP has the greatest impact on the contraction intensity, followed by the unemployment rate, science and education expenses and the average wage of on-the-job workers. Among the four influencing factors, only the unemployment rate promotes the contraction, and the other three influencing factors inhibit the formation of shrinking cities to various degrees.

With the improvement of people's living standards, water heaters almost into the various households. In the energy-saving emission reduction has become the trend of the times today, saving energy and reducing carbon emissions is the most fashionable way of life. Air source heat pump water heaters are increasingly being used in people's lives. It is well known that it has many advantages, safety, energy saving, comfort, environmental protection, but there are some factors that affect its development and promotion. This paper mainly discusses the development history of air source heat pump technology at home and abroad, working principle, working flow, turbo technology at present stage, efficient heat exchange, and the research status of air source heat pump technology, such as new type refrigerant and dual frequency compression frequency conversion, then it discusses the application of air source heat pump technology, has the advantage, and finally discusses its application and the existence of two major problems and suggestions for improvement.

In order to strengthen the study of soil-landscape relationships in mountain areas, a digital soil mapping approach based on fuzzy set theory was applied. Initially, soil properties were estimated with the regression kriging (RK) method, combining soil data and auxiliary information derived from a digital elevation model (DEM) and satellite images. Subsequently, the grouping of soil properties in raster format was performed with the fuzzy c-means (FCM) algorithm, whose final product resulted in a fuzzy soil class variation model at a semi-detailed scale. The validation of the model showed an overall reliability of 88% and a Kappa index of 84%, which shows the usefulness of fuzzy clustering in the evaluation of soil-landscape relationships and in the correlation with soil taxonomic categories.