There are numerous studies reported on the usage of the sapindus emarginatus (SE) fruit in cancer and other treatments in the past few years. In this study, crude SE fruit extract was prepared and it was further used to synthesis gold nanoparticles (Au Nps). The synthesized Au Nps were left embedded in the SE fruit extract. The Au Nps embedded in the SE fruit extract (SE-Au Nps) were characterized using UV-Visiable Spectroscopy, Centrifugal Particle Size analyzer (CPS), Scanning Electron Microscope (SEM) and Fourier Transform Infrared Spectroscopy (FTIR). MTT assay was carried out for both SE fruit extract and SE-Au Nps on MCF7 breast cancer cell line and thus compared. The UV-Visible Absorbance for the SE-Au Nps was obtained at 543 nm. The centrifugal particle size analysis of the Au Nps embedded in SE fruit extract showed the size of the nanoparticles to be widely varying with higher fraction of particles between the size ranges of 15 to 20 nm. The morphology of the Au Nps embedded in SE fruit extract was observed using SEM. The presence of Au Nps in SE fruit extract was confirmed using FTIR. The results of the MTT assay on MCF7 breast cancer cell line proved that the % cell viability was less for SE-Au Nps than that of the SE fruit extract alone. Thus, the antiproliferative activity of the SE fruit extract was significantly enhanced by embedding it with Au Nps and it can be effectively used in therapeutic applications after further studies.

In order to seek management alternatives for anthracnose caused by the fungus Colletotrichum gloeosporioides in blackberry (Rubus glaucus Benth.), at the Tibaitatá Research Center of the Colombian Agricultural Research Corporation AGROSAVIA (formerly CORPOICA), an experiment was conducted to evaluate the effect of the application of the major elements nitrogen (N), phosphorus (P), potassium (K) and calcium (Ca) on infections of the fungus C. gloeosporioides strain-52. For this purpose, a randomized complete block design was used with an arrangement of treatments in an orthogonal central composite design. To evaluate the relationship of fertilization levels and disease severity, an artificial inoculation was made on thorny blackberry stems using 0.5 cm mycelial discs at a concentration of 9.53 × 104 conidia. Observations consisted of: disease severity (S), incubation period (IP) and rate of development (r). Data analysis was done by the cluster method on the severity variable, a Pearson correlation analysis between variables, as well as a regression to estimate the effect of nutrients applied on the severity of C. gloeosporioides strain-52. The treatments were concentrated in four groups with the ranges (in parentheses) S (15.9% and 91.8%), PI (9 and 15.3) and Tr (0.0254 and 0.0468). A positive and significant correlation was observed between S and r (P < 0.001) and a negative correlation between PI with S and r (P < 0.001). By means of regression analysis, a linear model was generated that showed a reduction in disease severity with increasing N dose and an increase with the levels of P and Ca applied.

Heat removal has become an increasingly crucial issue for microelectronic chips due to increasingly high speed and high performance. One solution is to increase the thermal conductivity of the corresponding dielectrics. However, traditional approach to adding solid heat conductive nanoparticles to polymer dielectrics led to a significant weight increase. Here we propose a dielectric polymer filled with heat conductive hollow nanoparticles to mitigate the weight gain. Our mesoscale simulation of heat conduction through this dielectric polymer composite microstructure using the phase-field spectral iterative perturbation method demonstrates the simultaneous achievement of enhanced effective thermal conductivity and the low density. It is shown that additional heat conductivity enhancement can be achieved by wrapping the hollow nanoparticles with graphene layers. The underlying mesoscale mechanism of such a microstructure design and the quantitative effect of interfacial thermal resistance will be discussed. This work is expected to stimulate future efforts to develop light-weight thermal conductive polymer nanocomposites.

In the present study, friction damper, an energy dissipating passive device is explored to reduce the response of open ground storey building under lateral loading due to earthquake. This damper is installed in the selected bays of open ground storey so that the response is reduced. The masonry infill wall is macro-modeled in the form of compression only diagonal members. Three different types of bracing system were installed along with Pall friction damper – single diagonal tension – compression brace with friction damper, tension only cross brace with friction damper and chevron brace with friction damper were modeled using Wen’s plastic link element in SAP2000. G+4 storey buildings were analyzed using nonlinear time history analysis. The storey displacement and inter-storey drift for all the cases were compared in the study.

Taking six typical forest communities in Taizhou Green Heart (ⅰ: Liquidambar formosana + Ulmus pumila + Celtis sinensis; ⅱ: Celtis sinensis + Pterocarya stenoptera + Pinus massoniana; ⅲ: Sapindus mukorossi + Sapium sebiferum + Cupressus funebris; ⅳ: Liquidambar formosana + Acer buergerianum + Cupressus funebris); ⅴ: Celtis sinensis + Ligustrum compactum + Pinus massoniana; ⅵ: Machilus ichangensis + Sapindus mukorossi + Acer buergerianum) as the research objects, 5 indicators: Shannon-Wiener (H), Patrick richness (R1), Margalef species richness (R2), Pielou evenness (J) and ecological dominance (D) were used to analyze species diversity in forest communities. The results showed that: (1) the community was rich in plant resources, with a total of 50 species belonging to 40 genus and 31 families, including 19 species in tree layer, 22 species in shrub layer and only 9 species in herb layer, few plant species; (2) the species richness and diversity index of tree layer and shrub layer were significantly higher than that of herb layer, but there were differences among different communities in the same layer, and no significant difference was reached; (3) the species richness and community diversity of the six communities showed as follows: community VI > community I > community II > community IV > community V > community III.