Every production day in Nigeria, and in other oil producing countries, millions of barrels of produced water is generated. Being very toxic, remediation of the produced water before discharge into environment or re-use is very essential. An eco-friendly and cost effective approach is hereby reported for remediative pre-treatment of produced water (PW) obtained from Nigerian oilfield. In this approach, Telfairia occidentalis stem extract-silver nanoparticles (TOSE-AgNPs) were synthesized, characterized and applied as bio-based adsorbent for treating the PW in situ. The nanoparticles were of average size 42.8 nm ± 5.3 nm, spherical to round shaped and mainly composed of nitrogen and oxygen as major atoms on the surface. Owing to the effect of addition of TOSE-AgNPs, the initially high levels (mg/L) of Total Dissolved Solids (TDS), Biological Oxygen Demand (BOD) and TSS of 607, 3.78 and 48.4 in the PW were reduced to 381, 1.22 and 19.6, respectively, whereas DO and COD improved from 161 and 48.4 to 276 and 19.6 respectively, most of which fell within WHO and US-EPA safe limits. Particularly, the added TOSE-AgNPs efficiently removed Pb (II) ions from the PW at temperatures between 25 ℃ to 50 ℃. Removal of TOSE-AgNPs occurred through the adsorption mechanism and was dependent contact time, temperature and dose of TOSE-AgNPs added. Optimal remediation was achieved with 0.5 g/L TOSE-AgNPs at 30 ℃ after 5 h contact time. Adsorption of Pb (Ⅱ) ions on TOSE-AgNPs was spontaneous and physical in nature with remediation efficiency of over 82% of the Pb (Ⅱ) ions in solution. Instead of discarding the stem of Telfairia occidentalis, it can be extracted and prepared into a new material and applied in the oilfield as reported here for the first time.

Adsorption is a widely used method for the treatment of dissolved contaminants. Various agro-industrial wastes have been explored as potential adsorbents, showing high efficiency in dye removal. Each adsorbate-adsorbent pair needs kinetic, and equilibrium models to scale up this process. In this work, the equilibrium, kinetics and thermodynamics of the corn Tuza-Red 40 system were evaluated under batch system at ph = 2.0 at temperatures of 25, 40, and 55 °C. The Langmuir, Freundlich and Temkin models were selected for the isotherm representation, while the Lagergren, Ho, and Elovich equations for the kinetics of the process. The Freundlich model presented the best fit to the isotherms, the adsorption kinetics was best described by the Ho equation, and the values for Gibbs free energy and entropy indicated the spontaneity and feasibility of the process.

Xylene isomers are notorious chemical hazards, and their efficient removal from water solutions is still challenging. The current study reports a polymer nanocomposite as a potential adsorbent for successfully removing dissolved xylene isomers from contaminated water. Polystyrene-1D multiwall carbon nanotube nanocomposite (PS-MWCNT) adsorbent was prepared using the one-step bulk polymerization method. Mesoporous PS-MWCNT was prepared using the nano-crystallization phase separation method. The sulfonation of the mesoporous PS-MWCNT nanocomposites was carried out by treating the samples with concentrated sulfuric acid at elevated temperatures. The sulfonated PS-MWCNT (HO₃S-PS-MWCNT) was found to be a potential adsorbent for dissolved xylene isomers from water solution. In addition, the HO₃S-PS-MWCNT can be efficiently recycled for up to 10 consecutive cycles with negligible decline in adsorption values. The exhibited equilibrium adsorption, rate of adsorption, and rapid regeneration of the HO₃S-PS-MWCNT are clear indications for the possibility of practical utilization of these adsorbents in large-scale water treatment plants.

The porous carbon/Ni nanoparticle composite was prepared by a freeze-drying method using NaCl as the template. It was applied in the effect of the concentration, adsorption time, and temperature of adsorption on the adsorption behavior. The kinetic model and the adsorption isothermic fitting results show that the adsorption behavior fits with the pseudo-secondary dynamics and the Langmuir isothermal model, indicating that the adsorption process is monolayer adsorption. Thermodynamic results indicate that the adsorption process is spontaneous physicochemical adsorption. The fitting showed that the porous carbon/Ni nanoparticle composites reach 217.17 mg·g^-1, at 313 K indicates good adsorption for Congo red.

One of the most important ways to achieve the goals stipulated by the Paris (2015) Agree-ment on climate change is to solve a two-fold task: 1) the adsorption of CO2 by the forest communities fcom the atmosphere during global warming and 2) their adaptation to these climate changes, which should ensure the effectiveness of adsorption itself. Report presents the regional experience of the numerical solution of this task. Calculations of the carbon balance of forests in the Oka-Volga River basin were carried out for global forecasts of moderate and extreme warming. The proposed index of labile elastic-plastic stability of forest ecosystems, which characterizes their succession-restorative po-tential, was used as an indicator of adaptation. A numerical experiment was conducted to assess the effect of the elastic-plastic stability of forest formations and the predicted climatic conditions on the carbon balance. In the upcoming 100-year forecast period, the overall stability of forest formations should increase, and to the greatest extent with extreme warming. Accordingly, one should expect a significant increase in the ability of boreal forests to ab-sorb greenhouse gases. It is determined unambiguous picture of a significant increase in the adsorption capacity of boreal forests with a rise in their regenerative potential.