Rapid global warming and continuous climate change threaten the construction industry and human existence, especially in developing countries. Many developed countries are engaging their professional stakeholders on innovation and technology to mitigate climate change on humanity. Studies concerning inclusive efforts by developing countries’ stakeholders, including Nigeria, are scarce. Thus, this study investigates the construction industry’s practitioners’ preparedness to mitigate climate change through pre- and post-planning. Also, the study appraises climate change’s impact on construction activities and proffered measures to mitigate them. The research employed face-to-face data collection via a qualitative approach. The researchers engaged 33 knowledgeable participants. The study covered Abuja, Benin City, Owerri, and Lagos and achieved saturation at the 30th participant. The research employed a thematic approach to analyse the collected data. Findings reveal that Nigerian construction practitioners cannot cope with climate change impacts because of lax planning and inadequate technology to mitigate the issues. Also, the government’s attitude towards climate change has not helped matters. Also, the study suggested measures to mitigate the impact of climate change on construction activities in Nigeria. Therefore, as part of the research contributions, all-inclusive and integrated regulatory policies and programmes should be tailored toward mitigating climate change. This includes integrated stakeholder sensitisation, investment in infrastructure that supports anti-climate change, prioritising practices in the industry to achieve sustainable project transformation, and integration of climate change interventions into pre- and post-contract administration.

This study deals with the impact of Vietnam bank size, loans, credit risk, and liquidity on Vietnam banks’ net interest margin, which are crucial for economic development. High profit margins result in a lower bad debt ratio due to timely loan collection and good liquidity. This study applies a panel data model to evaluate the relationship among bank size, loans, credit risk, liquidity, and marginal profitability, which are increasingly important in commercial bank growth. Data were collected from 2010 to 2022, and test methods were applied to select a good-fit model. Realizing that the factors that have a close correlation and affect the profit margin are 33.6% and 16.07%, 75.2%, 37.51%, 64.30%, and 41.11%, and R2 is 59.04%, respectively, this suggests that financial managers need to develop appropriate strategies and policies to adjust the factors that adversely affect commercial bank profitability.

How to improve enterprise performance has been a research topic widely studied by scholars for a long time. As economic globalization deepens, the business competition becomes increasingly harsh. Technology-based small and medium-sized enterprises (SMEs) play an important role in the rapid development of the country’s economy, especially in China. This study aims to investigate the mediating effect of knowledge integration capability in the relationship between corporate social capital and enterprise performance. The sample group used in this study were 300 technology-based SMEs in China. The research tool was a questionnaire adapted from previous scholars, which passed assessment in terms of content validity and reliability. Data were analyzed using structural equation modelling. The results show that: 1) corporate social capital has a positive impact on enterprise performance, but the impact differs between well-performing and poor-performing enterprises; and 2) knowledge integration ability plays a mediating role in the relationship between corporate social capital and enterprise performance, and the mediating role is the same for both well-performing and poor-performing enterprises. But it played a partial mediating role in the good-performance comparison group and a complete mediating role in the poor-performance comparison group. This study is useful for enterprise management in cultivating and developing the abundant social capital of enterprises and expanding channels for knowledge integration ability to increase enterprise performance.

The Cu_2–xSe nanoparticles were synthesized by high temperature pyrolysis, modified with aminated polyethylene glycol in aqueous solution and loaded with compound 2,2′–azobis[2–(2–imidazolin–2–yl)propane] dihydrochloride (AIPH). The obtained nanomaterials can induce photothermal effect and use heat to promote the generation of toxic AIPH radicals under the irradiation of near-infrared laser (808 nm), which can effectively kill cancer cells. A series of in vitro experiments can preliminarily prove that Cu_2–xSe–AIPH nanomaterials have strong photothermal conversion ability, good biocompatibility and anticancer properties.

Energy shortages and environmental damage have become serious problems facing the society today. Biomass can be a renewable energy source, which large-scale development and utilization are of great significance to industry and social life. Biomass pyrolysis technology can achieve effective utilization of biomass energy. It is necessary to optimize the pyrolysis reaction technology and device for realize the industrialization and large-scale production of biomass energy.

For five different regions in Kırklareli province, heavy metals; such as Pb, Ni, Cu, Mn, Cd, Cr, Co, Zn, Mo, and Fe in the mixture of leaves and flowers from linden trees (Tilia tomentosa L.) were analyzed by using flame atomic absorption spectroscopy after the samples were dissolved with microwave method. Also, organochloride pesticides; such as ∑BHC: [α-BHC, β-BHC, γ-BHC, and δ-BHC], ∑DDT: [4,4’-DDD, 4,4’-DDE, and 4,4’-DDT], α-Endosulfan, β-Endosulfan, Endosulfan sulfate, Heptachlor, Heptachlor-endo-epoxide, Aldrin, Dieldrin, Endrin aldehyde, Endrin ketone, Endrin and Methoxychlor in these samples were determined by utilizing gas chromatography mass spectroscopy after the samples were prepared for analyses by using QuEChERS method. The metal concentrations in the samples were in the range of 45.3 to 268 mg/kg for Mn, 0.25 to 18.8 mg/kg for Cu, 11.5 to 46.1 mg/kg for Zn, 128 to 1310 mg/kg for Fe, 10.4 to 38.6 mg/kg for Mo, 0.82 to 1.34 mg/kg for Cd, 0 to 6.45 mg/kg for Ni, 0 to 19.2 mg/kg for Pb, and 0 to 8.25 mg/kg for Cr. Moreover, the concentrations of organochloride pesticides in samples were usually determined to be lower than their maximum residue level values given the pesticide residue limit regulation of Turkish Food Codex.