Surface-enhanced Raman scattering (SERS) spectrum has the characteristics of fast-detection, high-sensitivity and low-requirements for sample pretreatment. It plays a more and more important role in the detection of organic pollutants. In this study, MIL-101 and Au nanoparticles were prepared by hydrothermal method and aqueous solution reduction method respectively, and MIL-101/Au composite nanoparticles were prepared by electrostatic interaction. The SERS properties of the composite substrate were optimized by adjusting the size of Au nanoparticles and the surface distribution density of MIL-101 nanoparticles. The detection limit of Rhodamine 6G (R6G) for the composite substrate with the optimal ratio was investigated, which was as low as 10^–11 M. It is proved that MIL-101/Au composite nanoparticles have high sensitivity to probe molecules. When they are applied to the detection of persistent organic pollutants, the detection limit for fluoranthene can reach 10^–9 M and for 3,3’,4,4’-tetrachlorobiphenyl (PCB-77) can reach 10^–5 M.

Objective: To study the growth, accumulation and soil nutrient content of each overseeded species under different interharvesting intensity treatments of Eucalyptus, and to explore the best re-cultivation method suitable for mixed overseeded species after Eucalyptus interharvesting. Methods: In Guangxi state-owned Qipo forest, Eucalyptus tailorii with different planting densities (DH32-29) were mixed with Castanopsis hystrix, Mytilaria laosensis and Michelia macclurei, and four different treatments (CK, LT, MT and HT) were established for re-cultivation of Eucalyptus near-mature forests with different logging intensities, and the differences in growth conditions and soil physicochemical properties of each species were analyzed. Results: (1) As the proportion of Eucalyptus allocation decreased, the growth of Eucalyptus diameter at breast height, tree height and individual wood volume could be promoted; the growth of the three parameters of HT and MT Eucalyptus were significantly different from LT and CK. (2) The average wood volume per plant of the set species in the CK and LT treatments was Mytilaria laosensis > Michelia macclurei > Castanopsis hystrix, while in the MT and HT treatments it was Mytilaria laosensis > Castanopsis hystrix > Michelia macclurei. (3) The differences in soil aeration, total saturated water holding capacity, capillary water holding capacity, and field water holding capacity in soil layers of different depth varied. In the same soil layer, soil aeration, total porosity and capillary porosity were HT > CK > LT > MT; saturated water holding capacity and capillary water holding capacity were HT > CK > LT > MT, while field water holding capacity was CK > HT > LT > MT. (4) Organic matter, pH, total nitrogen, total phosphorus, total potassium, fast-acting nitrogen, fast-acting phosphorus, and fast-acting potassium changed with varying soil depth in each treatment.

The agronomic use of mushroom post-harvest substrates (SPCHs) in horticultural seedbeds could be an interesting alternative for the reuse of these wastes in line with the European circular economy strategy. This work evaluates the potential use of four treatments with different SPCHs, mushroom (-Ch), mushroom (-St), mushroom compost (-CO), and a mixture (SPCH-Ch and SPCH-St) as substrates for lettuce and chili pepper seed germination. The trial was carried out in a germination chamber using commercial compost as a control treatment. The evaluation was based on its chemical (salinity, N and C content), physical (bulk and real density, porosity and water retention) and plant effect (germination and biomass) characteristics. Of the chemical properties studied, the high salinity in SPCH-Ch and SPCH-CO was a limiting factor for the development of the horticultural species evaluated (electrical conductivity 1:2.5; p/v; ~11 dS m^-1), and low germination percentages were observed. Regarding physical properties, porosity and water retention, the SPCH-CO, SPCH-St and mixture treatments presented some values outside the optimal range established for germination substrates. In the case of SPCH-St, its high C/N ratio could be a limitation for supplying N to the crop. In relation to biomass production (aerial and root) of lettuce and chili pepper, all the treatments evaluated obtained similar values to the control treatment. The mixed treatment presented the highest biomass values, significantly higher in the lettuce crop. In general, the mixed treatment proved to be the best alternative for use in the seedbed.

In this study, the influence of sewage sludge ash (SSA) waste particle contents on the mechanical properties and interlaminar fracture toughness for mode I and mode II delamination of S-glass fiber-reinforced epoxy composites was investigated. Composite laminate specimens for tensile, flexural double-cantilever beam (DCB), and end-notched fracture (ENF) tests were prepared and tested according to ASTM standards with 5, 10, 15, and 20 wt% SSA-filled S-glass/epoxy composites. Property improvement reasons were explained based on optical and scanning electron microscopy. The highest improvement in tensile and flexural strength was obtained with a 10 wt% content of SSA. The highest mode I and mode II interlaminar fracture toughness’s were obtained with 15 wt% content of SSA. The mode I and mode II interlaminar fracture toughness improved by 33% and 63.6%, respectively, compared to the composite without SSA.

A metakaolin-based geopolymer was fabricated with 5 ratios of two different nanomaterials. On the one hand, silicon carbide nanowhiskers and, on the other hand, titanium dioxide nanoparticles. Both were placed in water and received ultrasonic energy to be dispersed. The effects on mechanical properties and reaction kinetics were analyzed. Compared to the reference matrix, the results showed a tendency to increase the flexural strength. Probably due to the geometry of the SiC nanowhiskers and the pore refinement by the nano-TiO₂ particles. The calorimetry curves showed that incorporating TiO₂ nanoparticles resulted in a 92% reduction in total heat, while SiC nanowhiskers produced a 25% reduction in total heat.

Many questions of control theory are well studied for systems which satisfy to the relative degree definition. If this definition is fulfilled then there exists linear state-space transform reducing system to a very convenient canonical form where zero dynamics is a part of system’s equations. Algorithms of such reduction are well-known. However, there exist systems which don’t satisfy this definition. Such systems are the subject of investigation in the presented paper. To investigate their properties here we suggest to consider an analogue of the classical relative degree definition – the so-called column-wise relative degree. It turned out that this definition is satisfied in some cases when classical relative degree doesn’t exist. We introduce this notion here, investigate it properties and suggest algorithm for reducing systems to the column-wise relative degree compliant form if possible. It is possible to show that systems with column-wise relative degree also can be reduced to a convenient canonical form by a linear state-space transformation. Some problems arise from the fact that some systems which do not have relative degree can be reduced to a form with it using linear inputs or outputs transform. Here we show that this is an interesting mathematical problem, which can be solved with the help of properties of relative degree, formulated and proved in this paper.