Based on Landsat–7ETM + images of 2007 and 2012 and Landsat–8 images of 2018, this study took Fuyang City, Anhui Province (Yingzhou District, Yingdong District, Yingquan District) as the research object, and made a quantitative analysis of land use/cover change in Fuyang City from 2007 to 2018 with the Environment for Visualizing Images (ENVI) software. According to the data of land use types in three phases, the article analyzes the development trend of various land use types and the main reasons for the changes of land use, which provides a certain basis for the urban planning and environmental construction of Fuyang City. The results show that with the rapid economic development and continuous improvement of the urbanization level in Fuyang City during 11 years, the area of various land types in the study area has changed greatly. The area of construction land area changed by 448.27 km², with an increase of 543.57%; the area of arable land changed by 597.52 km², with a decrease of 34.74%; the area of bare land changed by 26.00 km², with a decrease of 80.68%. The changes were closely related to the rapid economic and social development in the study area. Under the influence of environmental protection policies and environmental awareness, the area of forest land changed by 85.00 km², with an increase of 97.58%; the water area changed by 84.35 km², with an increase of 201.39%.

Introduction: Growth, yield and quality of okra (Abelmoschus esculentus (L.) Moench) are related to fertilizer application, being nitrogen (N) the most outstanding, due to its direct relationship with photosynthesis and vegetative growth of the plant. Objective: The objective was to evaluate the agronomic and productivity characteristics of okra as a function of N dose. Materials and methods: The study was conducted at the experimental area of Campus Gurupi, the Universidad Federal de Tocantins (UFT), Brazil, in two planting periods (autumn/winter and spring/summer). The experimental design used was randomized block design (RBD) with six treatments (50, 100, 150, 150, 200 and 250 kg N ha^-1) and four replications. Urea was used as a source of N. The characteristics evaluated were: productivity, average fruit mass, height and plant chlorophyll index. Results: Productivity and plant height were superior in the fall/winter crop. Mean fruit mass and chlorophyll index were not influenced by planting time. For productivity, a linear response was obtained with increasing dose up to the limit of the N dose used (250 kg ha^-1), with a mean value higher than 14 t of fruit. Mean mass and plant height responded linearly to increasing N dose. Nitrogen affected the chlorophyll index, with maximum values of 45.96 and 47.19, observed in the two evaluation periods. Conclusion: Planting time and N content in the soil interacted with plant height, being favorable in the period without precipitation. N influenced all the characteristics, demonstrating the importance of nitrogen fertilization in the development of okra plants.

The xanthorrhiza species of the genus Arracacia belongs to the Apiaceae family and is known for its ability to generate tuberous reservoir roots that are harvested annually and marketed fresh in South American countries such as Colombia, Brazil, Venezuela, Peru, Bolivia and Ecuador. In Colombia, arracacha is planted mainly in 15 departments and the regional cultivars are differentiated by the color of the leaves, petiole and tuberous root, the best known being amarilla común or paliverde, yema de huevo, and cartagenera. There are studies that have characterized regional materials by applying a limited number of descriptors, but they do not allow knowing the morphology and phenotypic differentiation of each one; therefore, their definition and characterization constitute a support in breeding programs that allow the efficient use of the genetic potential and increase the knowledge about the diversity of cultivars. Phenotypic characterization and description of three cultivars was performed during two production cycles (2016 and 2018) in two phases (vegetative and productive) applying 74 morphological variables (42 qualitative and 32 quantitative) organized in seven groups of variables: plant, leaf, leaflet, petiole, propagule, stock and tuberous root. A factorial analysis for mixed data (FAMD) was performed, which incorporated a multivariate analysis with all variables and identified 11 discriminant variables, 8 qualitative and 3 quantitative, which can be used in processes of characterization of arracacha materials. A morphological description of each cultivar was made, which means that this is the first complete characterization study of regional arracacha materials in Colombia.

Electrospinning nanofiber membrane has the advantages of wide raw materials, large specific surface area, and high porosity. It is an ideal separator material for lithium-ion batteries. This paper first introduces two common electrospinning nanofiber diaphragms: polymer, polymer, and inorganic composite, and then focuses on the modification methods of composite modification, blending modification, and inorganic modification, as well as the methods of electrospinning nano modified polyolefin diaphragm. Finally, the development direction of the electrospinning lithium-ion battery separator has prospected.

The danger of riverbed processes is considered. Their speed varies from the first few months of the flood to the most dynamic process in nature. It happened in front of people. This may make life on the river bank and the utilization of river resources more difficult. This paper introduces the causes and consequences of the danger performance of riverbed processes, and focuses on the mapping methods of the danger assessment of riverbed processes: determining the danger degree of riverbed processes and different methods of displaying it on the map. An example of displaying danger on the previously drawn map is given, and the distribution of different types and expression degrees of dangerous riverbed processes under various natural conditions in Russia is briefly analyzed.

The wave effect and the shyness phenomenon in Alnus acuminata (Kunth) are crown parameters rarely studied, but important in the quality of the wood of standing trees, therefore, a morphometric modeling of the crowns of Alnus acuminata in homogeneous forests in the Sierra Norte de Puebla was carried out. In 20 rectangular sites of 1,000 m², the following were evaluated: total height (TA), normal diameter (ND), crown diameter (CD) and crown cover (CC). The Kruskal Wallis test was applied to data that did not meet the assumption of normality; for those that did, analysis of variance (ANOVA) was used, with Tukey mean comparison tests (α ≤ 0.05). The forest value index was 14.99, so its two-dimensional structure is normal based on DN, AT and CC. Its average slenderness index was 93.52, which makes the tree not very stable to mechanical damage. The life-space index was 38.92, which is high indicating that trees with low intraspecific competition developed better. At the canopy level, a pattern following an upward, oscillatory and constant wave effect was observed in groups of 10 trees. The shyness phenomenon showed an average crack opening of 27.39 cm between canopies, so this phenomenon is well defined for the species. It is concluded that in the crowns of Alnus acuminata, the wave effect is observed as a consequence of inequality in the acquisition of resources, and one way to minimize this inequality is through the phenomenon of botanical shyness.